20 Most Recent
Creda 24 in. DWI34 Built-in Dishwasher Questions & Answers
The dishwasher will not draw
Check if there is a screen in the supply line, these can become blocked due to scale deposits from the mains. If there is no screen check that the inlet solenoid valve has not got blocked. If none of the above help, check that there is power getting to the solenoid valve when the machine is supposed to be on the fill cycle. If no power is getting to the valve, the timer might be faulty. (You can try hand filling the machine and see if it goes through a cycle, at least up to the rinse stage, this will tell you if the timer control is working).
6/26/2011 9:59:59 AM •
Creda...
•
Answered
on Jun 26, 2011
Door clip is broken, can
Yes It's a relatively easy fix, turn off the power then just remove the screws on the inside around door and separate the panel, you will need a star head driver or a hex driver will work to. from the inside you can remove the wire harnesses then unscrew the door latch with a fillips driver and replace.
This repair usually takes me about 10 minutes.
Good luck
5/23/2011 8:41:19 AM •
Creda...
•
Answered
on May 23, 2011
Causing electric trip to go off
Heating element at bottom of dishwasher cause of "throwing" trip, told this by manager of local electric store where machine was purchased.
10/12/2009 6:33:02 PM •
Creda...
•
Answered
on Oct 12, 2009
Keeps blowing the fuse in the house
Try to turn off everything else that is on the same circuit then turn on the dishwasher. If the breaker still trips then the circuit breaker might be malfunctioning or the dishwasher might be defective (in which case the circuit breaker is doing exactly what it is designed to do.) I would bet that it's the dishwasher thats causing the problem. Check with the manufacturer to see if there are any recalls on that model.
8/17/2009 5:04:27 PM •
Creda...
•
Answered
on Aug 17, 2009
Karcher Puzzi 100 Spray pressure low
1. CHECK THE WATER SUPPLY: MAKE SURE THE WATER SUPPLY IS ADEQUATE AND NOT BLOCKED.
2. CLEAN THE NOZZLES: CHECK THE NOZZLES FOR ANY BLOCKAGES OR DEBRIS AND CLEAN THEM THOROUGHLY.
3. ADJUST THE PRESSURE SETTINGS: ENSURE THAT THE PRESSURE SETTINGS ON THE MACHINE ARE CORRECTLY ADJUSTED.
4. CHECK THE HOSES: INSPECT THE HOSES FOR ANY KINKS OR BLOCKAGES THAT MAY BE RESTRICTING THE WATER FLOW.
5. CONTACT CUSTOMER SUPPORT: IF THE ISSUE PERSISTS, CONTACT KARCHER CUSTOMER SUPPORT FOR FURTHER ASSISTANCE.
3/28/2024 10:15:14 AM •
Dishwashers
•
Answered
Yesterday
DIO3T131FEUK Integrated dishwasher has power but won't switch on
1. CHECK IF THE POWER CORD IS PROPERLY PLUGGED IN AND THE POWER SUPPLY IS WORKING.
2. MAKE SURE THE DOOR OF THE DISHWASHER IS FULLY CLOSED AND LATCHED.
3. CHECK THE CONTROL PANEL FOR ANY ERROR CODES OR INDICATORS.
4. TRY RESETING THE DISHWASHER BY TURNING OFF THE POWER SUPPLY FOR A FEW MINUTES AND THEN TURNING IT BACK ON.
5. IF NONE OF THE ABOVE WORK, THERE MIGHT BE A FAULTY CONTROL BOARD OR WIRING ISSUE THAT NEEDS TO BE ADDRESSED BY A PROFESSIONAL TECHNICIAN.
3/28/2024 10:12:54 AM •
Dishwashers
•
Answered
Yesterday
Not finding what you are looking for?