20 Most Recent
Epson Stylus 2200 InkJet Photo Printer Questions & Answers
Work in Europe?
According to the rear panel of my 2200, it will accept 120VAC 50 ~ 60 HZ. Which means that outside of a proper plug adaptor, it should work fine. You need to adapt the epson power cable to whatever the French use. Be sure it is 110~120 VAC. Ran into some 220 in Italy
Epson stylus cx5500 printer problem
probably refers to empty cartridges
everything has a service life and it could be a possible part that is wearing out and needs replacing
you have 2 options --ignore it untl it stops performing
or get in a service technician
Printer won't recognize cartridge
I had the same problem. I'm not sure but I think I replaced the cartridges when the printer was on because I turned the printer off and removed one of the cartridges. When I turned the printer back on it recognized that cartridge but not the others. I turned the printer off again, rmoved all cartiridges and put them back in when the printer was still off. When I turned the printer on again I had no problems. So...try turning off the printer, rmove all cartridges, then put them back in and restart printer. Hope this works for you .
Why does my Epson 2200 printer not even try to feed a sheet of paper when I run a status sheet from the control panel?
Hi!
Is the printer driver installed in a correct way and it is the correct version for your system? Try to uninstall it and reinstall it downloading the latest correct version from the Epson site!
If you wanna print a nozzle check try this:
1- Power the printer off
2- While holding the page key down, press the power key, DON'T release the page key, hold it down for 5-10 seconds
the printer will print the nozzle check
You can also do a cleaning cycle by holding down the ink key untill the cleaning process starts.
Did you try this on other PCs?
Let me know! :)
Best regards!
How to change ink cartridge on nx220 printer
Turn the printer on.
Lift the lid, to expose the print-carriage and the print-heads.
Wait a few seconds, and the print-head (holding the ink-cartridges) will slide over to some point where you can remove the cartridge.
Push on the "holder" surrounding the ink-cartridge, to "unlock" it, and gently lift the ink-cartridge out. Insert the replacement, "lock" it in place, and close the lid.
Printing paper choices
The paper types available in the driver are dependent on which type of black ink cartridge is loaded in the printer. If the Photo Black ink is loaded, you should have various glossy paper choices. If the Matte Black ink is loaded, you will have a choice of plain or Matte paper types. Once the cartridge is switched, you will get the corresponding paper choices.
I have an Epson Stylus
That is a maintenance error. It means the protection counter has reached it's limit.
Read
HERE for more info on how to reset the protection counter .
Not finding what you are looking for?