20 Most Recent Indesit W 123 Front Load Washer - Page 7 Questions & Answers

This usually indicated a problem with the pump. There is a belt which turns the agitator, spins the drum, and turns the pump, which is what removes the water. Since the agitator works and the drum spins, the pump is probably faulty.

This video will show you how to keep your soap draw clear and how to service the parts Please remember to subscribe to our YouTube channel for all appliance tutorials a 4 THUMBS rating is appreciated for answering your FREE question.

I have the solution for your query.
In your browser bar, type in ----
indesit user manuals

Click on---
manuals- user guides- handbooks- indesit service
In the search box enter your model and down load the relavent instructions.
Please leave a fixya rating if you consider my solution appropiate to your problem.
Thankyou.

Loose mounting points or broken pins. If not that then possibly drum shaft could be cracked.

Probably blockage in pressure system

I had thi problem.I removed the heater element but there was nothing wrong with it when tested .Do not do this as it is hard to get element back inWhat I done was remove the top of machine and pulled connector of temperature knob It was corroded.I sprayed the connection with WD40and shoved it on and off a couple of times and hey presto it worked .Themachine is heating again

hi there. its likely that there are coins etc in the pump filter,which causes the filter to jam.usually a little persuasion and patience will give you access.try fast left and right turns ,with the emphasis on anti clockwise.otherwise you may need to strip down the pump.patience usully works though!
hope this helps!steve

You may download the manual from here.

this is a cold fill only machine as nearly all machines today are designed that way to save energy , as you only heat the water that you need

Click on any of the advertisements here on Fixya for washer parts, or look for the grey bar on Fixya and type indesit washer spares. Helped?

Hi,

If you have checked everything else, then it may be the drain pump or the "filter/catch". There is no real filter but rather is a part of the drain system. Normally it is at the very bottom of the machine. You need to remove the lower front panel. There would be 3 clips that holds it in place. Once the inside is exposed, there would be a black circular cover at the right hand side. Unscrew it out and clean the inside. It would normally be filled with water and some other "stuff" so pls have cleaning materials handy and/or anything to absorb the spilling water. You can now check the pump, the impeller and verify that indeed there are no clogs/blockage.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.