Intel Desktop Boards D845EPT2 and D845EBG2 Product Guide 28 Removing the AGP Card Follow these instructions to remove the AGP card from the RM: 1. Remove the screw (B) that secures the card’s metal bracket (A) to the chassis back panel. 2. Push back on the RM lever (D), as shown in Figure 9, until the retention pin (C) completely clears the notch in the card. 3. Pull the card straight up (E). OM10595ABCDEFigure 9. Removing the AGP Card Connecting the IDE Cable The Intel® boxed desktop board package includes an IDE cable. The cable connects two drives to the desktop board. The cable supports the Ultra DMA-33 and ATA-66/100 transfer protocols. Figure 10 shows the correct installation of the cable. /NOTE ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive.
Guru