20 Most Recent Integra DTR 5.6 Multi Media Amp Questions & Answers

reset receiver if that does not work You will have a defective processor pcb

Help here https://www.google.com/search?q=integra+dtr+5.3+goes+into+protect+mode ..

Hi, Please confirm that the remote has power and move closer to the receiver and attempt to use the remote again. If the remote works when you're closer, then this means that your batteries needed to be updated. If the remote does not work even within 1 foot of the receiver, please clean the section of the receiver that receives the remote signal. You can then restart your receiver and attempt to use the remote again. If this fails, then you can attempt to re-program your remote to the receiver once more. Otherwise, you might need to work with Integra to further troubleshoot the possible source of the issue. Thank you.

http://www.integrahometheater.com/faqs.php Check the connections and try a master reset? Perform a master reset. To do the reset you need to turn the receiver on, then on the front panel of the receiver press and hold the "VCR/DVR" button while doing that press the "STANDBY/ON" button. You will see the word "Clear" in the display screen and the receiver will go into standby mode.

You have a short somewhere in the speaker wiring.

You have a defective processor pcb assembly and it must be changed.

You will have bad output transistors, a $124 to 150 repair in shop service