20 Most Recent ThermoFisher Scientific Jouan CR3i Centrifuge, Table Top Questions & Answers


But a new scope. Having the crosshair reseated will cost you more than getting a new BSA scope.

Science &... | Answered on Apr 03, 2018


Manuals are available from PHC. Email service@us.phchd.com or call Technical Support at 800-858-8442 ext. 48299.

Science &... | Answered on Apr 03, 2018


Check the fuses located on both sides of the mains connection in the back of the autoclave. One of them has blown. If both check ok, then check the connection tho the mains. You may have a faulty ground. If you are not comfortable doing this, contact Eschmann at tel:+44 (0)1903 753322
Fax: +44 (0)1903 875789
info@eschmann.co.uk

Science &... | Answered on Apr 03, 2018


If you're clever with electronics and can solder, consider an LED replacement. Do you have any data on the voltage, current, or lumen rating of the bulb?

Science &... | Answered on Mar 25, 2018


Choosing the right laboratory for conducting various tests and analyses can be a tricky affair. If there is any discrepancy in readings, it can be cause quote a stir. Thus, it is imperative that the staff operating the equipment of the laboratory must be expertly trained. The equipment itself must be top notch in quality. LiveScanLabs has managed to meet all this criteria. They have centers in Hialeah, Hollywood, Fort Lauderdale, Pembroke Park and Pembroke Pines. They conduct Fingerprint Analysis, Fingerprint Testing, **** Analysis, **** Testing, DNA Analysis, DNA Testing and regular health tests as well. Visit their website at www.livescanlabs.com.

Science &... | Answered on Mar 03, 2018


Are you sure that the lid safety interlock switch isn't damaged/dirty? If the centrifuge can't detect that the lid is closed it will never start. Sometime it just needs an extra push down on the lid.

Science &... | Answered on Jan 17, 2018


It sounds like either the bulb is loose or the connection between the bulb socket and a wire is loose. To check both, Loosen the screw knob on the underside of microscope and open the panel to expose the bulb. Use a small screwdriver to loosen the screws holding (the two screws closest to the bulb) the prongs of the halogen bulb. Note that the prongs of the bulb are held in place by small brass plates which shift slightly when the screws are loosened. Remove the old bulb. Important: Do not touch the new halogen bulb with bare hands. Wear gloves or hold the bulb using tissue or lens paper. Body oils may damage the halogen bulb. Insert prongs of replacement bulb into top of socket (above the brass plate) and tighten screws slightly. (The brass plates will move up to hold the prongs in place.) Close door and hand tighten the thumbscrew knob.
If this does not work, contact Premier for assistance: Premiere® Microscope Service, 7241 Gabe Court, Manassas, VA 20109 (703) 330-1413

Science &... | Answered on Jan 15, 2018


The error E61 indicates that your water pump has failed or is not active. You should check the pump and replace it if needed. You should also check the steam generator sensor and replace it if needed.

For more information, contact Euronda at Water inlet pump inactive or call (+39) 0445 329811 (Vicenza, Italy)

Science &... | Answered on Jan 15, 2018


If this is a microscope, the part you are referring to is the stage control. You can get the part from C&A Scientific at http://www.cnascientific.com or by calling 703.330.1413

Science &... | Answered on Jan 15, 2018

Not finding what you are looking for?
ThermoFisher Scientific Jouan CR3i Centrifuge, Table Top Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top ThermoFisher Scientific Science & Laboratory Experts

ray gallant

Level 3 Expert

51513 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

20350 Answers

S J Parkin
S J Parkin

Level 2 Expert

56 Answers

Are you a ThermoFisher Scientific Science and Laboratory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

ThermoFisher Scientific Science & Laboratory

  • ThermoFisher Scientific Science & Laboratory

Most Popular Question

sterilizing autoclave ses 2000 little

  • Science & Laboratory
Loading...