20 Most Recent
Samsung SF-565P All-In-One Laser Printer Questions & Answers
Required user manual
Hi,
This is the
download link to the user manual.
Let me know if that doesn't fix you up as the link may not be static but dynamic based on the search lookup which is Samsung's method of presenting the downloads today..
Regards,
Worldvet
Samsung printer sf 565p empty
menu # 1934 to enter tech mode.
menu left arrow till "new cartridge" enter enter
menu #1934 to exit tech mode.
Or simply replace the 63~100ma fuse on the cartridge.
Open heat error ?
Disassemble fuser and inspect thermistor, thermostat and heat lamp. Replace broken part.
I am recieving fax but
When the fax comes through, is anything printed on the paper or not. if nothing is being printed on fax page, only blank page comes out then reduce the moderm speed for your fax. it will solve the problem.
Why toner empty error in samsung sf 565p
I have an SF-555P and have installed numerous cartridges. The last one was a Samsung brand and it didn't have the little fuse taped on the top. I never knew what this was fur until I had problems. When I first installed the new cartridge the "Toner Low" display remained lit. I shook the cartridge and it persisted but it printed well. Then about 100 pages later I got the "TONER EMPTY" and the printer stopped. After researching the issue I found that the fuse is actually a reset for the printer counter and when the new cartridge was installed without the fuse, it never reset.
You will need a 5X20 Fast acting fuse, no greater than 315 ma. You can buy a 4 pack from Radio Shack for about $3 (P N 2701046). Install it with a piece of electrical tape in the slot on the toner cartridge and make sure the contacts are exposed. The printer will blow the fuse and reset the counter. Don't use a bigger fuse, a slow-blow or anything that won't burn open quickly or you will be buying a new printer.
No power. Unit seems dead.
Have you checked the fuse in the plug?
If you have then the internal power supply is faulty, this should only be repaired by an experienced technician.
Regards
Mike
Copy is not clear
if copy is not clear.that this can be due to many reasons.---
1)The drum must have gone faulty or may be the drum is at the end of its life and need replacement.----
2)The toner powder inside the cartridge or the drum has caught moisture.replace the cartridge and check.-------
3)if everything above is okay then the laser beam inside the laser assembly has dust on it causing shaded image and distorted copy.in that case the printer needs to be serviced and laser ccd device needs to be cleaned properly.-----
This will help. Thanks please keep
updated.please do rate the solution positively .thank you for using fixya
Not finding what you are looking for?