20 Most Recent Zebra 105SL Thermal Label Printer - Page 4 Questions & Answers

You can either see my simple Tool with 3-easy Steps to create a barcode label!What kind of barcode symbology do you want to use?

First Step: Do a configuration print on both units. If you encounter differences, correct it and/or do a hardware reset on both unit.Second Step: Give it a try. If there are still differences ...Third Step: Save the "print data" in a file -> you can do it in the drivers option. Then do again a hardware reset and take the file and send it to the printer (you have to get the same printout with this methode!). If yes you can search backwards ...

This may be due to the fact that your ribbon is too translucid, back quality transfer films.
To overcome this you must use a bit of scotch and a piece of film and stick it on the ribbon sensor.
Else try a callibate to see if the error is not solved

This sounds like a mismatch between the printer settings in the print driver and the label settings in your label design software. In the printer driver - printer preferences- set the physical label dimentions.Also set the printing defaults to the same settings.In you design program ensure your label size is the same as the printer driver and also you can set the print preferences in the same program, ensure they all match and hey presto it works. But if nt then contact www,lancerlabels.co.uk, they will talk you through the problem on the phone. They will not charge for the advice.

Not a question.

Krishan, sorry there are no settings that will allow you to do this on the 105SL. If the printer code expecting a 203 DPI printhead and you have a 300 DPI Printer then your label will print out much smaller then normal.

If you are printing labels with a label printing package (such as Seagull Bartender for Windows) then all you need to do is to install the proper printer driver. If you have your printer attached to a system that is sending "straight" ZPL (Zebra Printing Language Code) then your out of luck.

Hope this helps

[email protected]

HiTry calibrating the printer.Click on the link below for a video tutorial on the same.www.racoindustries.com/zebra-105sl-printer-calibration-video.htmHope it helps.