Wiz
pbabin
Guru
Guru
15 solutions
Problems with Kenwood KAC-9152D Car Audio Amplifier?
Kenwood KAC-9152D Car Audio amp
I have a ken-wood kac-9152d car amp and its the same when the bass hits it cuts off for a few then back on again and...
1 Solution
I have a ken-wood kac-9152d car amp and its the same when the bass hits it cuts off for a few then back on again and...
my kenwood amp wont turn on
i have this kenwood amp hooked up to two boston aoustics g2's and it was slammin but i unhooked it to put clips on the...
1 Solution
i have this kenwood amp hooked up to two boston aoustics g2's and it was slammin but i unhooked it to put clips on the...
fan stays on, light turns off
I connected all the wiring and when i turn the car on, the red light stays on for a second and then fades off but the...
1 Solution
I connected all the wiring and when i turn the car on, the red light stays on for a second and then fades off but the...
heating up and clipping
i have 3 kicker cvr competition i have them hooked up into 2 ohm the amp will heat up and clip whats wrong
1 Solution
i have 3 kicker cvr competition i have them hooked up into 2 ohm the amp will heat up and clip whats wrong
bass knob/remote for kac-9152d
i have this awsome amp but no way of using it. because i have no in line remote for frequency or volume. would a...
2 Solutions
i have this awsome amp but no way of using it. because i have no in line remote for frequency or volume. would a...
my amp wont turn on
i bought my amp about 5 months ago and it worked realy good but when i turn it up about 60 percent of the way it would...
2 Solutions
i bought my amp about 5 months ago and it worked realy good but when i turn it up about 60 percent of the way it would...
music not playing from subs
i dont kno what could be wrong, i hooked up different subs the music cut out... i thought it was because i didnt have a...
1 Solution
i dont kno what could be wrong, i hooked up different subs the music cut out... i thought it was because i didnt have a...
How to install a car Amplifier
- Written by DrElectrics
Specifications
Key Features
Amplifier TypeMono Channel
Bass BoostWith Bass Boost
BridgableNot Bridgable
Power Output
RMS Power at 4 Ohms500 W x 1
Performance
Bass Boost Frequency40 Hz
THD at Rated RMS Power.08 %
Signal to Noise Ratio100 dB
Frequency Response5 Hz - 200 Hz
Low - Pass Frequency50 Hz - 200 Hz
Other Features
MOSFET ampYes
3 Way ReadyNo
Kenwood Contact Information
Main support number1-800-KENWOOD
Sponsored Links
Top Experts
Master
Repair Service
About | News
| Contact
| Find Products
| Find Cars
| Terms
| Privacy Policy
| FAQ
Tags | Blog | Repair Service Directory | Extended Warranty | Partners | Careers |
Tags | Blog | Repair Service Directory | Extended Warranty | Partners | Careers |