26CQ-C5410/5310/5210/5110UCQ-C5410/5310/5210/5110U27Station PresetUp to 6 stations can be stored in each of the FM1, FM2, FM3 and AM band selections.Auto Preset Memory (APM)Automatically save stations with good reception in the preset memory.1Select a band. (previous page)2Press and hold [BAND](APM:Auto Preset Memory) for more than 2 seconds.The 6 stations with good reception will be automatically saved in the memory under preset number 1to 6.Once set, the preset stations are sequentially scanned for 5 seconds each. (scanning)Manual Preset MemoryManually save a station in the preset memory.1Select a band and frequency. (previous page)2Press and hold one of the buttons from [1]to [6] until the display blinks once.Note: To stop scanning, press one of the buttons from [1]to [6].New stations overwrite existing saved stations after this procedure.Preset Station Calling1Select a band. (previous page)2Press one of the preset buttons from [1]to [6].RadioDirect Memory (D·M)This is a useful function that can call broadcast stations directly during playback in other modes (CD, CD Changer, etc.), even when the power is off.Your favorite radio station can be memorized in [D·M](direct memory).Default: FM 87.9 MHzMemorize1Select a band and frequency.2Press and hold [D·M]for more than 2 seconds.Frequency is saved in the memory.Note: New stations overwrite existing saved stations after following this procedure.Recalling the Direct MemoryPress [D·M].Press [D·M]again to cancel.[%] [$] (TUNE)Caution:To ensure safety, never attempt to preset stations while you are driving.[D·M] (Direct Memory)ENGLISH7ENGLISH8Preset buttons [1] to [6] (Preset station)[BAND] (APM:Auto Preset Memory)Display ChangePress[DISP] (display).[SOURCE]64975Car AudioSOURCEMUTEPOWERRANDVOL31 2DISPBANDREP65SETSEL#SCANMENUNUMBER80[DISP](Display)[SOURCE][%] [$](Tuning)[BAND](Auto Preset Memory)[1] to [6](Preset station)(Stereo) indicatorRadio ModePress[SOURCE]to select the radio mode.Radio mode display1BandPress [BAND].2Tuning[$]:Higher frequency[%]:Lower frequencyPress and hold [%] or [$] for more than 0.5 seconds, then release. Seeking will start.3Radio mode display (default)Clock displayPreset number[DISP] (Display)FrequencyBandDisplay off