INPUT SELECTORVOLUMEDOWN UPVCR 2VIDEO INL AUDIO IN RDVD 6CH INPUTTAPE MONITOR+–LRSUB WOOFERBASS/TREBLEBALANCEDIGITAL INPUT13[L, C, R, S, SL, SR, LFE]Program format indicators.Show the channels contained in the digital input signal. They donot light when input is analog.L: Front channel (left)C: Center channelR: Front channel (right)S: If the surround channel is monaural.SL: Surround channel (left)SR: Surround channel (right)LFE (Low Frequency Effects): Deep-bass effects. [FIX, %PRO LOGIC 2, PCM, , %DIGITAL]Signal format indicators.Light depending on the source you are playing.%DIGITAL: Dolby Digital sources: DTS sources%PRO LOGIC 2: The Dolby Pro Logic 2 circuit is being usedFIX: PCM FIX or DTS FIX modePCM: PCM FIX modeFor your reference ¡When playing videotapes (VCR 1)The picture remains on the screen even if you select TAPE, CD, orTUNER.¡Once you have set a mode (DSP, digital/analog input, or2-channel/6-channel input) for an input sourceThat mode is engaged whenever you reselect the input source.¡When DVD 6CH input is onSpeaker settings are ineffective. Change the settings on the DVDplayer if necessary.¡When input is DIGITALThe tape monitor cannot be used.¡When using a graphic equalizerSome distortion may occur, depending on the equalizer’s settings.¡To adjust the toneThe STEREO DSP mode must be on and input must be eitheranalog or PCM signals. You cannot adjust the tone while the DSP isdefeated or if DVD 6CH INPUT is selected.¡When using the subwooferYou cannot adjust subwoofer level while the DSP is defeated or ifDVD 6CH INPUT is selected.Sound can be distorted if you raise the volume while subwooferlevel is high. Reduce subwoofer level if this occurs.¡Improving receptionDSP DEFEATPress and hold [DSP SOUND MODE] until “DEFEAT” appears.Press and hold [DSP SOUND MODE] again to turn the DSP on.While the DSP is defeated, you cannot:– Select DSP sound modes,– Adjust the tone,– Output a test signal,– Adjust individual speaker output, or– Use digital input.Note[VOLUME]Volume control [INPUT SELECTOR]For selecting input. [DIGITAL INPUT]For switching between analog and digital input when you have selectedCD, DVD or TV. The button lights when digital is selected.[SUBWOOFER]Adjust the level in 5 steps. SW MIN, SW 5, SW 10, SW 15, and SW MAX.Select SW --- to stop output.[DVD 6CH INPUT]For switching DVD 6-channel input mode on or off.[TAPE MONITOR]For monitoring sound when recording to a 3-head cassette deck.Also used when you have connected a graphic equalizer to the TAPEterminals.[BASS/TREBLE, BALANCE, –, +, L, R]For adjusting the tone and balance.First select BASS, TREBLE, or BALANCE, then press [–, L] or [+, R] toadjust.[VCR 2]For a Video camera, etc.
Wiz