Top 20 Philips 60PP9352 60" Rear Projection Television Questions & Answers


it may be that the dish alignment needs resetting or the lnb is going bad

Philips 60PP9352... | 204 views | 0 helpful votes


Fault to the main power supply regulator section. Either it will be a separate board, or the part of main board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Pull up older posts.
http://electronicshelponline.blogspot.com/

Philips 60PP9352... | 36 views | 0 helpful votes


you might need a new bulb, bulbs average around 4000 hours, depending on the bulb, they range from 750-6000 hours

Philips 60PP9352... | 59 views | 0 helpful votes


I replaced bulb but still no picture

Philips 60PP9352... | 89 views | 0 helpful votes


the set uses two stk-392-120 convergence chips, both will need to be replaced and the set adjusted--tvrepair.com sells kits for this based on brand and model number.


10_26_2012_6_41_04_pm.jpg

Philips 60PP9352... | 65 views | 0 helpful votes


Problem is in standby power supply or microprocessor area---not the do it yourself repair and likely not economical to repair due to age and brand of set.

Philips 60PP9352... | 70 views | 0 helpful votes


The CRT coolant change is all mechanical which involves removing the crt and disassembling the coolant chamber so it can be cleaned then reassembled and filled with coolant the phillips CRT coolant kit from www.tvrepairworld.com has the coolant and the instructions for the repair on cd

Philips 60PP9352... | 330 views | 0 helpful votes


You cant. You will need the remote control to control the adjustments. You can get the remote for your model from www.tvrepairworld.com

Philips 60PP9352... | 57 views | 0 helpful votes


If the images are getting darker then its certainly an issue with the three CRT tubes that are dying. Slowly the images will get darker and darker till you can no longer see a pic. If the image level is viewable then a brigthness/contrast adjustment should resolve the problem atleast for now. Otherwise you will need to replace the three CRT tubes to resolve this problem. This being a high voltage repair its recommended that you seek the assistance of a qualified tech as we are dealing with 30,000V here. As my mentor always says your life and limb are worth much more than this

Philips 60PP9352... | 27 views | 0 helpful votes


If your talikng about alignment that is done through the Convergence feature. If its the color balance youre refering too its most likley indicating that the CRT coolant needs replacment as that will make the red Tube dominate and wash out both blue and green colors untill they appear dull and dim.

Philips 60PP9352... | 47 views | 0 helpful votes


If your TV looks 3D, warped, or distorted it likely has a convergenge problem.
If however it just looks dull, washed out, redish, or if it looks like objects on the screen have halos the fluid in the lens has soured.
You can search google for parts or you can get the parts with repair instructions from sites such as www.TvRepairKits.com

Philips 60PP9352... | 35 views | 0 helpful votes


The burned smell comes from a shorted parts.
This is usually a burned fusible resistor act as a guard when there is a short circiut to avoid further damaged to other parts. I've suspect that you have a short on the power supply section which is caused by voltage regulator. This is not DIY and quite technical so I've advice you to look for a qualified technician or repair shop to isolate the problem. This is fixable.

Thanks for using fixya.

Please rate my help.

Philips 60PP9352... | 59 views | 0 helpful votes


In most cases the HVG - Flyback has gone out on this model. We see this alot. The problem is they are very hard to find.

Philips 60PP9352... | 40 views | 0 helpful votes


That sounds to me like weak tubes or low emmission tubes. If it is old, it may be past its best and time for a new one.

Philips 60PP9352... | 29 views | 0 helpful votes


hello, you have a convergence problem. you need to replace the two stk, in the convergence board and check for bad fuses or resistors and replace them too, and your problem should be fix. if you need more help with your tv feel free to call me at anytime. 602-810-7149

Philips 60PP9352... | 52 views | 0 helpful votes


Most likely your bulb has burned out. Best replacements come from the OEM, and are fairly easy to change.

Philips 60PP9352... | 17 views | 0 helpful votes


I believe that it may be the projectors the earths gravitational pull pulls them out of alinement

Philips 60PP9352... | 47 views | 0 helpful votes

Not finding what you are looking for?
Philips 60PP9352 60" Rear Projection Television Logo

182 questions posted

Ask a Question

Usually answered in minutes!

Top Philips Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76060 Answers

matt martin
matt martin

Level 3 Expert

1255 Answers

Steve Allison
Steve Allison

Level 3 Expert

5569 Answers

Are you a Philips Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Philips Televison & Video

  • Philips Televison & Video

Most Popular Question

phillips 37fd9944 01s plasma tv power

  • Televison & Video
Loading...