20 Most Recent Dyson V6 Absolute Bagless Cordless Hand Vac - Page 7 Questions & Answers

The latch might be clogged with dirt or gunk

There is a lever on the back of the vacuum you can turn to allow the filter to come out.

If it has good suction but won't pick up dirt off the floor it probably needs the belts or clutch replaced.

Yes, It is possible

The filters might need cleaned or replaced.

Might be bad on/off switch.

The on/off power switch faulty. The switch gets used every time you use it.So It might be that.Unplug it and open the switch.You can use a meter to check it.If it's in the off mode and still sends a signal...it's the switch

Have you tried pushing the peg inwards? This locking peg should be spring-loaded, and tapered at the top to retract automatically when the handle is pushed down, like a folding umbrella. However, it could be jammed, so try manual force. The lock-peg may have trapped a piece of debris around its body.

Sounds IMHO like a faulty connection, faulty switch, or crack in cord. An electrician or somebody competent with power appliances and a test-meter will need to open and check cord first, then work forwards through switch, wires, motor brushes, etc.

That's dyson's way of laughing at you for spending 4 times as much as you should have for a vacuum that doesn't work any better than the rest of them

if you followed all instructions then return

Brush roll is probably jammed

It might be the clutch. Mine did it because there was dirt stock in the end caps if the roller. Instead of the belt breaking a clutch kicks in and makes a loud flapping noise.

Sorry. Almost all Dyson cordless machines last 2 years and fail. Don't get fooled again by advertising. buy a better brand next time. Local vac shop can help you decide what is a good choice for your needs.

This is common on the 25's. Take it to your local vac shop for repair. The pivot screw vibrates loose and binds the pivot point. This can be fixed. You probably need it serviced anyway as bagless machines need annual cleaning to perform properly.

The ball shell may be broken or damaged or the part on the vacuum where the bolt holds the ball shell on may be damaged. You will have to inspect these areas closely while moving the vacuum back and forth to narrow down where the problem is.

Model number needed.

Contact Dyson but I think you have a motor failure.

either battery or charger

It is either a wiring problem You must check voltage on the switch terminal using a DIM-be careful you could receive a shock sparks tripped breaker or the motor. I would lean toward the power cord it is not uncommon for them to breaker at the handle. The only parts available are the motor for around $85.00 and a power cord around $26.00. Motor number and fig number 120V Panasonic Motor SDS1301GND Part Number: DY-91166601 fig 25 Power cord Power cord Assy Part Number: DY-91426923 fig 38 Cable protector Cable Protector Part Number: DY-90338201 39 https://www.ereplacementparts.com/dyson-dc25-upright-vacuum-parts