Toshiba 61H71 61 in. Rear Projection Television

All Products > Toshiba > Projection Televisions

Problems with Toshiba 61H71 61 in. Rear Projection Television?

Troubleshooting and Support

Toshiba 61H71 blue convergnece cannot be...
I have read inputs to replacing the ics chip to correct this issue, but don't have any info on the exact kind of chip...

1 Solution

How to replace STK392-100?
I have a 61H70 and am trying to replace the two STK392-110's. After I opened the back cover, and removed the panel/board...

1 Solution

toshiba 61" part no. question?
do you know the part number for the high voltage transistor? mine has the same problem.

1 Solution

Toshiba 61h71 rear projection red...
The red gun has a pincushion problem and I think this is causing the red gun to go out of convergence. I don't have a...

1 Solution

Toshiba 61' cinema series rear projector
After pressing the power button on the red power led comes on steady for approximately 3 seconds and then it starts to...

1 Solution

PROBLEM W/ 61H70 CONVERGENCE
Hey guys I have a 61h70, the convergence is out of whack (3-d) effect across the bottom of the screen and the right top...

1 Solution

toshiba 61h70 blue to high
what ics do i need to repair this thankx

1 Solution

View All

Unsolved Support Problems

Post a New Problem

Toshiba 61H71 Hyper Board problem.
I too have a Hyper Board problem, # 23786198, can you advise me where the board is located when I open the back of the...

Post a Solution

61H70: How to remove the vertical boards...
I have a 61H70 and am trying to replace the two STK392-110's. After I opened the back cover, and removed the panel/board...

Post a Solution

red line across middle of screen and very...
There is a red line across the middle of the screen and the red is eliptical in the picture. Could it be the convergence...

Post a Solution