Unless other specified in paperwork, all Alpine receivers are 4ohm capable only. Now yes there are exceptions, but not many. Now for amp almost all alpine amps can be run in several different resistances. Basically for sure 4ohm, now depending on model some have abilities to go as low as 1ohm stable. But for most 2 ch alpine non special amps are all 4ohm and most 2ohm capable. Now better models can do things such as run 2,3,4 ch. And some can even get to .5 ohm loads stable.
? 4:49
https://www.youtube.com/watch?v=1wv1LzdUYiM
Sep 5, 2013 - Uploaded by Mx Car Audio
I recently bought the Alpine W940 and the bluetooth that connects to ... A simple reboot at the shop and the ...
www.brandsmartusa.com/pdfs/manuals/20181335.pdf
sp?ciales, de l'actualit? d'Alpine, et vous aurez une chance de remporter des prix. Gracias por adquirir ... MANUAL DE OPERACI?N .... Listening to the Radio .
I would think a 1000 watts would be enough for 2 10's. You can hook up two dual voice coil subs a few different ways. First thing I would check for is what ohmage your amp is rated for. You don't want to push a lower ohmage than what your amp is rated to handle. That is a good way to overheat & ultimately fry your amp. After that, you can wire your subs accordingly. If they are dual 2 ohm subwoofers, you can wire each of them as a 4 ohm load, 2 ohm load or even a 1 ohm load. I would personally go by what the amp is ratted for. Remember though, the lower you run the ohmage, the better base responce & harder the hit you will get.
manualslib.com is a 100% free online manual for any manual needed and if you want to buy there is that option to or simply just print out the pages if you have that much ink..but just an option...Hope this helps...
Hi ester, check the red and yellow wire connections. they need to be swopped. if that does not help then go to local installer for a full inpection of the alpine installation. cheers.
