20 Most Recent
Sharp AR-C270 Color Copier Questions & Answers
Error code E7-10
this problem comes from CCD unit please clean it and all area than fix it
The sharp AR-c270 has a
Hi
Error code F2 55 is a toner error. Make sure all the packing tape was removed from the toner, if a new toner was installed. Try and reseat the toner, and check plug-in sensor fixed with 2 screws on the rear side of the toner cartridge. Try to replace it with the one on the previous cartridge.
If this doesn’t resolve the issue then check the grid voltage, it may have happened due to low grid voltage. To check this you’ll need to check the power supply board of the machine for any disconnections or burnt components. Hope this helps... If it does please do not forget to accept the solution or post back for assistance.
Daniel
Arc 270 error code l404
That is a problem with the black motor, May have a bound up dev housing or drum unit. It is unlikely the motor has failed. But something is binding in your black imaging area.
My Sharp AR-C330 Has Fuser
Hi,
It is a leak from Fuser Oil Unit. You need to replace the Fuser oil Unit.Once replaced, it would fix the Problem.
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
Sharp ar-c330 with an error code of H4-01. Any
The fuser temperature is low.
Use sim. 5-02 to check blinking of the heater lamp.
if it blinks normally check the thermistor and the harness.
If it not lighted check the heater lamp and thermostat if its defective replace the heater lamp or the thermostat.
Code h4-00
It means you have a problem with the fixing unit or you have had to many paper jams in the fuser unit. It needs to be reset in service mode "14" Good Luck
Error code u0-80
Hello sir; U0-80 means PCU board have problem, send it store for repair.
Sharp ar-c330
Hi gw16336
It means the mainboard has a malfunction. The printer would need to be serviced by Sharp or a Sharp approved service centre.
MANUAL FOR SHARP ARC270
Here's a link to the manuals download page at Sharp:
http://www.sharpusa.com/products/TypeManuals/0,1083,18,00.html
They don't list an AR-C270, but a C260 is listed. Maybe it will give you some help. You can also try contacting their customer service through the site if you still need more information
Sharp arc 270 error code l4-04
Possible bind in one or more of the developer units. Replace as needed.
Sec. 11 Page 11-61 it talks about Paper Feed Drive Motor, it is the
same motor as the Black Developer Drive Motor.
For L4-04 swap those two motors around to troubleshoot bad motor
Sharp AR C-330 Error Code E 710
E7-10 refers to black shading correction.
sometimes caused by a poor conection between the icu and the ccd. check ribben cables.
Not finding what you are looking for?