20 Most Recent
Questions & Answers
#324 chak printer alram cameing
when you power on your fax machine and display show DATA ERROR its mean that 3 volts battery on the main board expired and lose all data fax number, logo and related with cartridge ink data so first of all you replace the battery. (this is a pure technical job and if your are not a technician you must take help of a technician)
After replacement of battery you power on fax machine and press
function key display show DATA REGISTRATION
press # display show #1SSSW
press left arrow key one time display show TEST MODE
press start/copy key display show TEST MODE -
press # display show AMI MODE
Press 7 display show FACULTY 1-6
press 5 display show INK CHECK 1-2
press 2 and start key
display show INK=YES and INS (ink level any one within 100 for example 42/205 you just remember first two digit of lest side)
press stop display show FACULTY 1-6
press 6 display show LOST INK CHECK
press start/copy key display show LOST INK CHECK -
press 2 display show SET LOST CNT
press start/copy key display show LOST INK= (here you enter the last left side two digit which you remember for example 42)
press start/copy key
press stop two times
and unplug fax and plug again now your fax machine is okkkkk
NOTE:- If you can't get the success first time you must try until you get the success because this is the only way to get success
on Jul 18, 2012
Canon Fax Machine B120 ##342
1.) press function then # u reach SERVICE MODE
2.) arrow right until TEST MODE confirm with Start / Enter (green button)
TEST MODE  - 
3.) press # ... u reach AMI MODE  - [*9]
4.) press 7 ... u reach FACULTY  - 
5.) press 6 ... .u reach LOST INK CHECK...confirm with green button...
u get  - ....
6.) press 2 u reach SET LOST INK CNT....confirm with green button...
u get LOST INK = 100 (in my case it was 100 ..this was the error..)
7.) press 0 (the digit zero..) confirm with green button...
8.) wait a few seconds....the unplug and reboot....
this worked in my case....
on Nov 13, 2010
HOW TO TURN OFF THE RING TONE OR TURN DOWN THE
Press Function and scroll to User setting with the right arrow(Nr 10 and 12 on the right hand side)and press start!Scroll to volume control and press start and u will be able to set it there!Just press start after setting each one you want!Good Luck!
on Nov 09, 2010
Not finding what you are looking for?