52Adjusting CRT Color ConvergenceThis TV has three color projection tubes: one for red, green, and blue. When mixed together inthe proper portions, the output of these three color tubes can produce any color. To producethese colors, however, the beams must be precisely aligned over each other so that the colorscan be mixed. The produce of aligning these picture beams is called “convergence”.Attention:• This adjustment will be needed only when the colors of the characters/lines are seperatedand lack in distinction.• If not, please don’t perform the adjustment.Colors may become seperated after the TV has been moved, or over a long period of time ifregularly subjected to low levels of vibrations. If the colors become seperated, please performthe adjustments below again.Press the MENU buttonto CONVERGENCEto operateThe convergance adjustment screen appears with crosses (+) displayed in 9 locations.Location where the crosses appear in 3 colors:Convergence adjustment is required. Perform step 1 and 2.Locations where the crosses are white:The convergence is adjusted correctlyIf all the crosses are white, no convergence adjustment is needed.1) Use the number buttons on the remote control to select the location tobe adjusted.The location of the crosses correspond to the positions of the numberbuttons on the remote control. A box appears around the selected cross.2) Adjust the three colored crosses until they overlap and appear as a single (white) cross.1) Press the SELECT button to change the color of the box to the color of the crossyou want to adjust (red or blue). You cannot adjust the green cross.2) Use the and buttons to adjust the position of the cross. To cancel the adjustments before completing the procedure, press the EXIT button.3) Press the ENTER button to end the convergence adjustment procedure.If you do not use the TV controls for roughly one minute, the convergenceadjustment screen automatically disappears.1+ 2+ 3+4+ 5+ 6+7+ 8+ 9+CONVERGENCE ADJUSTMENT SCREEN+ + ++ + ++ + +
Guru