<?xml version="1.0" encoding="us-ascii"?><rss version="2.0"><channel><title>Alcatel Newbridge MainStreet 3600 Multiplexer Support</title><link>http://www.fixya.com/support/p176642-alcatel_newbridge_mainstreet_3600</link><description>Solved  technical support problems provided by FixYa users.</description><language>en-us</language><copyright>Copyright (c) 2007  FixYa, LTD.  All rights reserved.</copyright><webMaster>info@fixya.com</webMaster><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate><ttl>80</ttl><item><title>no connect to rs232 serial, ports PC</title><link>http://www.fixya.com/support/t2798473-no_connect_rs232_serial_ports_pc</link><description>I need know serial port configuration and pinut of cable beste regardes</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>CPSS doesn't seem to work</title><link>http://www.fixya.com/support/t2641548-cpss_doesnt_seem_work</link><description>Hello, I want to enable CPSS on a E1 link between two newbridge nodes. The ports are configured ok but it doesn't seem to work. We use TS0 for CPSS. If CPSS works on that link I should see this in the Highlight CPSS mode? I hope you understand my...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Need support in configuration</title><link>http://www.fixya.com/support/t117511-need_support_in_configuration</link><description>We have a 3600 maint street that was put in back in 1999, since then most of the support for the node was handle remotely from off-island. Now that the off-island support which was our Long Distance carrier for TDM voice traffic BSI no longer has a...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>connect 3600 Alcatel over IP network</title><link>http://www.fixya.com/support/t544574-connect_3600_alcatel_over_ip_network</link><description>we have large network of alcatel 3600 carry over SDH. in near future, we will move to IP network to carry voice and data. 3600 is good product carry tel and low rate data for RTU site (small sites), we would like to keep it instead of replace it with...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Mainstreet 3600</title><link>http://www.fixya.com/support/t2082036-mainstreet_3600</link><description>Hello, I don't have lost any manual. I need some information about some parts of the newbrdidge mainstreet 3600. I  have a good description of the shelf. I am looking for technical information about few cards : 3600 mainstreet control card (...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>what is the function of expended card.how many band width of mux 3600 single shelf,doul shelf.27LC card suport daat limit.why we use expanded card in mux 3600?and DINC card use for how many data sopor</title><link>http://www.fixya.com/support/t2197267-function_expended_card_many_band_width</link><description>why we use expanded card in mux 3600?and DINC card use for how many data soport.and which modem sport this card?</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>CPSS</title><link>http://www.fixya.com/support/t2378458-cpss</link><description>What is difference between dedicated and shared CPSS ?</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>We have our all Nodes on our network . They are</title><link>http://www.fixya.com/support/t2372229-our_all_nodes_our_network</link><description>We have our all Nodes on our network . They are accessed by NMS at our HQ . But the problem is that When we locally want to access DXX Node via ANM , it is not accessed.Also DXX Nodes SP1 and SP2 are CPSS Configured . Why it is not accessed locally...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Can anyone please tell me What is the differenec</title><link>http://www.fixya.com/support/t2371690-anyone_please_tell_me_differenec</link><description>Can anyone please tell me What is the differenec between dedicated and shared CPSS connections ?</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>can u tell me function of DSP , LGS  CARDS IN 3600</title><link>http://www.fixya.com/support/t1715758-u_tell_me_function_dsp_lgs_cards_in</link><description>can u tell me function of DSP , LGS CARDS IN 3600 MUX</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>How do i remove Nmti if it affects port or frame relay resource</title><link>http://www.fixya.com/support/t1845088-remove_nmti_affects_port_or_frame_relay</link><description>Iam failing to remove this nmti ang i cant even configure the port and frame relay resource because of that problem</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>NewBridge 3600 Mainstreet</title><link>http://www.fixya.com/support/t865774-newbridge_3600_mainstreet</link><description>Hello, I cannot access my 3600 via SP1 or the DCE interface using the db9 serial cable I have used in the past. Does anyone know what the pinout and whether or not I need modem or null modem?</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Newbridge 3600 circuit signal fault</title><link>http://www.fixya.com/support/t368909-newbridge_3600_circuit_signal_fault</link><description>I am running a short hop from my NB 3600 at one substation to an NB 3630 at another less than 2 miles away. I am connected by T-Marc fiber boxes at both ends and have no perceivable problems there as my scada system is up and running. I am also...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Alcatel Mainstreet 3600 Anphenol PINOUT</title><link>http://www.fixya.com/support/t141051-alcatel_mainstreet_3600_anphenol_pinout</link><description>We have an old Newbridge (now Alcatel) Mainstreet 3600, that was reasigned to my group for band width management. The Mainstreet comes with dual E1 Cards with Coaxial terminals (75 ohms). We know that we can use the backplane Anphenol connector to...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Mainstreet 3600 cpss does not work</title><link>http://www.fixya.com/support/t296859-mainstreet_3600_cpss_not_work</link><description>My old 3600 suddenly does not respond to cpss or vt100 terminal, is it possible to reset the whole 3600 to default ?</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>problems in bsc &amp; bts</title><link>http://www.fixya.com/support/t343763-problems_in_bsc_bts</link><description>Plz tell me wats the problems found in BSC(V5.2), and BTS of LG</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>I need my yahoo password for</title><link>http://www.fixya.com/support/t3369043-need_yahoo_password</link><description>I need my yahoo password for (esanad2009@yahoo.com)</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>What is a multiplexer?</title><link>http://www.fixya.com/support/t263195-multiplexer</link><description>I'm actually kind of embarrassed to ask this, since my wife constantly talks about this kind of stuff, and I feel like such an idiot. I have absolutely no idea what a multiplexer is. Can anyone provide a detailed information for a technically...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>do not no how you put code in digibox</title><link>http://www.fixya.com/support/t1323214-not_no_put_code_in_digibox</link><description>i have a arnet a700c. i have got cables. but do i down load or do i manual put in code , but i do not know how to do it</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Need to install a modem on a Quick Eagle 4200T CSU</title><link>http://www.fixya.com/support/t292362-need_install_modem_quick_eagle_4200t_csu</link><description>Do I connect an external modem to the comm port? I have an external modem on my router, would like to use this if possible. Currently this modem set for 9600, 8 data bits, 1 stop bit, no parity. Any config change I must do in the 4200T to make this...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Confer with me please... thanks.</title><link>http://www.fixya.com/support/t1096726-confer_me_please_thanks</link><description>Can you help me with this problem, which is a subSet of a larger problem and verify that I'm seeing what I'm seeing in results? Thanks, WV</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>mypsace</title><link>http://www.fixya.com/support/t1116902-mypsace</link><description>how do i unblock myspace</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>how do i key in code for digibox</title><link>http://www.fixya.com/support/t1402053-key_in_code_digibox</link><description>can you please tell me how to enter code on digibox? thanks</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>I have pelco dx 8000 DVR and the (first in - first</title><link>http://www.fixya.com/support/t1900621-pelco_dx_8000_dvr_first_in_first</link><description>I have pelco dx 8000 DVR and the (first in - first out) recording technique is not working so that the recording stop when the HDD capacity is full I need your advice in this regard Thanks</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>i change my password,then yahoo not sign in</title><link>http://www.fixya.com/support/t2739284-change_password_yahoo_not_sign_in</link><description>i change my password,then yahoo not sign in</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>Problem in MS ACCESS</title><link>http://www.fixya.com/support/t296704-problem_in_ms_access</link><description>HI, My name is Ranjit and i have a problem in MS access when i am running query it's consume 2GB space in my PC .... and same query running in another PC it's taking 200MB space ....i have repaired the access but still not working and i hve a 2003...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>I CANT SiGN ON TO MY YAHOO</title><link>http://www.fixya.com/support/t3565728-sign_yahoo</link><description>I can't seem to sign in on my yahoo messenger. I've tried to sign in on my cell fone and even express, They said that im already signed in. I don't know how to fix the problem..it says that ''You have been signed out because you signed in on a...</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item><item><title>lost all channels</title><link>http://www.fixya.com/support/t1250700-lost_all_channels</link><description>i have lost the channels on my arnet a700c cable box how do i get them back thank you .</description><pubDate>Sat, 26 Dec 2009 03:34:19 GMT</pubDate></item></channel></rss>