Mini glossary 75 OHM RF CABLEThe wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of you Entertainment Machine.300 TO 75 OHM ADAPTERA small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end. P A G E 6Hook Up Your Antenna to the TVIf you have a 75 ohm RF cable,then you don’t need anyadapters!Remember, when screwing RFcables onto jacks, clockwisetightens, and counterclockwiseloosens. Locate the Antenna/Cable jack onthe back of your EntertainmentMachine.Connect the cable that runs fromthe wall directly to this jack,according to the diagram to theright.Remove the back of the remoteand put in two AA batteries.Plug in your EntertainmentMachine. Do not plug it into aswitched outlet. YourEntertainment Machine isdesigned to operate on householdcurrent, 120-volt 60 Hertz AC donot attempt to operate it on DCCurrent.Go to page 10 to Auto Programyour Entertainment Machine.12345back of remoteFlat wire antenna toEntertainmentMachineConnect an antenna to your Entertainment MachineRF coaxial wire(75ohm) AntennaTV backTV back panel(expanded view)AntennaCableTV backFlat wire(300 ohm)Antenna300/75 ohmAdapterTV back panel(expanded view)AntennaCable2 0 6 - 3 5 5 1“Entertainment Machine” is a trademark of Zenith Electronics Corporation.Antenna toEntertainmentMachine
Guru