Playing sources0637EnChoosing the input signal• Default setting: AUTOYou need to hook up a component to both analog and digital inputs on the rear of the receiver to select between input signals. •Press SIGNAL SEL (SIGNAL SELECT) to select the input signal corresponding to the source component.Each press cycles through the options as follows:The AUTO setting automatically switches to DIGITALif a digital source is detected, other-wise the signal select will be ANALOG. DVD 7.1chwill only appear when DVD/LDis selected.When set to DIGITAL or AUTO, 2DIGITALlights when a Dolby Digital signal is input, and DTS lights when a DTS signal is input. • This receiver can only play back Dolby Digital, PCM (32kHz–96 kHz) and DTS digital signal formats (including DTS 96kHz/24 bit). With other digital signal formats, set to ANALOG. • You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make the proper digital connections (page 17) and set the signal input to DIGITAL.• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.Listening to multi-channel playbackRECEIVER CONTROLSIGNAL SELDIGITALDVD 7.1 chAUTOANALOGINPUT SELDVDVCRCD-RTVRCVTVCTUNCDMULTI CONTROLRECEIVERRECEIVER CONTROLSTANDARD
Guru