20 Most Recent
Mitsubishi VS-50705 50" Rear Projection Television - Page 4 Questions & Answers
Mitsubishi 50705
Good Day, tree64;
More than likely the convergence problem the TV has wont be resolved by adjustments. In your situation, moving TV, the problem most likely is poor solder connections on the convergence IC's. They are large devices attached to very large heat-sinks, and have numbers on the IC'c like STK 392-560.
If no poor connections....replce.
Good Luck, big IRISH.
ThankYou
youre welcome, they will be able to help you out.
Oh wow
I work at a site that rebuilds circuit boards as well as sells remanufactured boards. You can send them an email and see what the rates are. Dawn in the office could explain that policy to you or refere you to one of the support staff. heres a link.
http://servicemanuals.vstore.ca/
Mitsubishi VS-50705 convergence problem.
There should only be a couple of STKs, the R's are resistors, they STKs should cost under $20. This should be everything you are looking for. If you need anything else, let me know.
CHASSIS: VZ7
MODELS: VS-45605 / VS-50605 / VS-50705 / VS-55705 / VS-60705 / VS-70705
Ref # / Part # / Part Name & Description
IC8C01 267P141030 HIC- STK392-110
IC8C02 267P141030 HIC- STK392-110
Parts
Thank you, same to you and let me know if you need assistance.
Other parts
The cleaner will work. but the liquid if its CRT coolant, and in that model I would bet that it is. Coolant is corrosive so i would at least heat the solder on those components just to evaporate any coolant that has seeped dow the components legs as it can and will eat at the pin/solder connections.
Help me
Go tu SET UP menu and change de option of SCREEN SAVER to off position and try again
Screen
Hi.
Call to Mitsubishi Service Manager
Santiago A. Bañuelos
Mitsubishi Digital Electronics America
Tel. 559-589-1290
Fax 559-589-1460
HELP? LOL.
i commented on your other post about that issue.
OK, parts
radio shack wouldnt have that part. I can try to track one down for you, But I would be surprised if that would solve your problem all by itself. How many components had the liquid on them? As they will need to be resolderd at the very least.
Liquid
It could be from one of the capacitors in the tuner itself. Look at the board closely inside the tuner and see if you notice any of the capacitor leads being corroded with a gree substance on the leads that would indicate the capacitor is leaking.
Rolling picture
Try replaceing capacitors C2C52 10uf 50V capacitor and also C2P05 100uf 16V capacitor. these are both on the signal board. It that doesnt correct the issue replace IC2P01 which is the 9volt regulator also located on the signal board. That should take care of your problem
Mitsubishi VS-50705 covergence problem.
Take the parts you want replaced into Radio Shack and they should be able to match them up quickly and sell you what you need. It should be fairly cheap too. If you still need the numbers let me know but this would be the best way to do this.
Cracking sounds
either the flyback or the HV splitter are the two most likely causes followed by one of the CRTs.
Not finding what you are looking for?