20 Most Recent
Questions & Answers
Sc 542 error code
Error SC 542 indicates a fuser temperature problem. Once the error is detected, the printer is toast until you manually clear the error from the keypad. Even though the printer is physically fine, it won?t come ready until the prior error condition is cleared.
The magic keystrokes, clear the error code:
In order to clear error SC542, you must perform procedure 5810.
Press and hold online + escape, then power on.
Use up and down arrow keys to select SP2
Use up and down arror to locate SP5
Use up and down arrow keys to select 810
Confirm the selection
Power off and on.
The error code is now cleared.
on Jun 11, 2018
RICOH 2015 error code sc 500
Main motor/ transport motor lock/ fusting motor error.
The only thing you can do is check for any obstructions in the machine.
That needs to be looked at by a service because the problem could be a motor, a pcb, or a power supply.
It can be a lot of troubleshooting to do.
on Apr 11, 2017
1600l sc code how to reset
press the orange key for say three times and press 107 and then press and hold the clear key for about three to four seconds .
the machine zill take you to the sp mode.
turn off the machine and put on again after a minute.
on Dec 20, 2015
Changed email hosting, now scan to email does not work
I'm confused. Are you saying that the programmed addresses don't work, but if you manually enter an address you can send?
Was your Gmail ( or another Gmail) account formerly the account to which the machine's settings were associated?
In order to use the scan to email, whatever settings have changed in your main email account, for example: username, password, SMTP & POP servers, etc, must be changed to match.
I am prettty sure you may have some difficulty, however if your new host uses Email encryption (SSL) , because I don't think that machine is compatible, so you may have to (somehow) configure an extra email account within your Outlook, or whatever you use that does not require authentication.
on May 20, 2015
Sc901 at 2015
The mechanical total counter is disconnected.
• User removed the counter while it was operating
• Poor connection
• Mechanical total counter defective
on Jun 13, 2014
Not finding what you are looking for?