My Clean Light was flashing, so I reset the dishwasher as mentioned. When I did the next wash, the...
(More)
My Clean Light was flashing, so I reset the dishwasher as mentioned. When I did the next wash, the sensor light didn't come on with the wash cycle. The the wash cycle continued for several hours (2+ hours), before I decided to cancel the wash cycle. What could be the problem?
kenmore 655.13222 k601 bought 5 months ago after insalation machine stops and clean light comes on...
(More)
kenmore 655.13222 k601 bought 5 months ago after insalation machine stops and clean light comes on flashing. had a repair man in changed circut board. month later of same issues told us the drain was not connected properly. today had a service man in and a wire was off to the element. now it runs a full cycle. what i would like to know is how long should all the cycles be if set to normal or fast etc. and when heated dry is selected should dished be fully dry . cause on normal - with heated dry turned on - everything is still wet like machine just turned off nore do the modes on the dishwasher change ie light stays on for normal clean but never lights up at rinse or drying just normal to clean? any one any ideas?
It leaks out of the float switch, occasionally. I think it comes from the float switch because it...
(More)
It leaks out of the float switch, occasionally. I think it comes from the float switch because it drips off the bottom of the switch. When it leaks the amounts vary from hardly any to a cup.
Part of the top spray arm has broken off (#3378144) of my ultrawash kenmore 665. Where can I find...
(More)
Part of the top spray arm has broken off (#3378144) of my ultrawash kenmore 665. Where can I find that part to replace it?
I have a kenmore dishwasher model#665.17014400. the soap dispenser does not open in cycle. I...
(More)
I have a kenmore dishwasher model#665.17014400. the soap dispenser does not open in cycle. I replaced dispenser because of high ohm's reading ,but it still does not open. which is the next place to look?
My Kenmore diswasher just started making loud noises during the wash cycle. I took apart the inside...
(More)
My Kenmore diswasher just started making loud noises during the wash cycle. I took apart the inside of the washer looking for some loose piece but couldn't find one. I read another fix about using a tie wrap to the spray arm, for a GE but wasn't sure that was my issue or if it would work with a Kenmore since I didn't quite understand where they were tying it to. I think it still runs ok, just really noisy, and I don't want to do damage to it so we are looking for solutions before I have to spend the money on a repairman. thanks
Regardless of which type of wash cycle we use it will not run. It sticks in the "sensing"...
(More)
Regardless of which type of wash cycle we use it will not run. It sticks in the "sensing" and "heating pause" mode with 76 minutes on the timer. From what I understand, the machine is designed to wait to start until the water is sufficiently preheated. The heating element gets hot but the machine will not advance beyond that point. It just stays in that mode with 76 minutes remaining, regardless of how long we let it continue to try to run.
Dishwasher model number 665,16032402 Serial number: FS40007265 Problem: "Clean" light...
(More)
Dishwasher model number 665,16032402 Serial number: FS40007265 Problem: "Clean" light constantly blinking. Dishwasher will not 'start' or do any other function. Computer glitch? How do we reset??
Kenmore Model 665.1703 clean light flashing. toggles sani-rinse and heated dry buttons. turned on...
(More)
Kenmore Model 665.1703 clean light flashing. toggles sani-rinse and heated dry buttons. turned on but motor not spinning. Motor or start capacitor?