http://www.fixya.com/support/p133398-kenmore_23822_top_load_washerSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comSat, 05 Dec 2009 03:02:05 GMT80http://www.fixya.com/support/t3573750-kenmore_direct_drive_model_110kenmore direct drive, model 110-82672100: agitator spins ok, but loud clunking noise under load.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3523035-machine_will_not_spin_unless_open_doorMachine will not spin unless i open the door once the spin cycle begins and then close it again. Water drains without spinning.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3448623-leaking_from_backleaking from back near drain tubeSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2710836-washer_drainwasher won't drainSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3411252-washing_machine_will_not_spin_sometimesmy washing machine will not spin sometimes and will not drainSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3378636-washer_appears_short_in_control_panelMy washer appears to have a short in the control panel. Stops during some cycles, and doesnt work on the cold water choice. However, if i press hard on the panel, the cold will begin to fill the drum. I cant figure how to open the panel to see if its...Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3327530-little_oval_hole_washer_lidThe little oval hole where the washer lid with a pin sticks into to make the machine run is not functioning. We can bang the lid or put a screwdriver down in the oval hole to maintain contact, but it's getting more and more difficult to find the spot...Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3302047-machine_out_balance_re_arrangeMachine is out of balance. You can re-arrange clothes, it still vibrates all over the froor during spin cycle.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3264708-wont_spin_rinse_cyclewont spin on rinse cycleSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3263400-washer_will_not_drain_completelyThe washer will not drain completely.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3212544-cloths_wont_rinse_completely_stillcloths wont rinse completely; still water in bottomSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3199794-kenmore_series_80_model_23822_typeKenmore Series 80, Model: #23822 Type: 3. Spin cycle problem: When in spin it makes a high pitch whine and gets out of balance. It progressively gets worse on higher speed spins. Will complete a full cycle wash. Problem started after a unbalanced...Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3200534-pressure_switch_locatedWhere is the pressure switch located on the kenmore washer?Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3197631-agitator_working_slower_normal_pleaseAGITATOR WORKING SLOWER THAN NORMAL. PLEASE HELP. THANK-YOUSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3168559-hair_clothing_in_washerWhen we wash our clothes in our washing machine, we get clumps of hair on them when they come out. Is there anything we can do with the washer to prevent this?Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3151768-washing_machine_not_workinghi my washing machine is not working properly,when we close it, not getting start.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3109546-washer_all_over_placeI have a Kenmore 80 Series washer that i recently replaced a brake in. it started to wobble and dance just before i replaced the brake. when i took it apart i noticed the retaining clip had come off and the brake was riding the shaft. so i replaced...Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3004741-agitator_not_working...only getting a humming sound....i think a small pillow may have caused the problem....also if you need to check the belt on washer or dryer how do you go about it?Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3072243-washer_all_over_placei recently replaced the clutch on my 23832 ( the retaining clip had come off and the clutch was riding all over the shaft. after replacing it with another good clutch off anaother machine, assembeled, it starts to go into the spin mode, and after...Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3064822-water_trickles_out_when_filling_insteadIt's a Kenmore 110 or 90 series washer. The hot water quit filling first and now only the cold fills but it is two little trickles from each side of the filling spout.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t3054517-top_loading_kenmore_80_series_modelI have a top loading Kenmore 80 series Model # 23832 washing machine. The washer will not spin. The motor is working, but the drum is not spinning. Is there a belt or gear that needs replaced? If so, what do I need to do?Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2971819-tub_fills_water_followed_humming_soundKenmore washer.....the tub fills with water followed by a humming sound and no agitationSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2937603-agitator_bottom_moves_top_notI've got a Kenmore series 80 washer. Everything works fine except the top part of the agitator, that cycles the clothes around, doesn't move. The bottom part moves, but the top seems to have disengaged somehow. Thoughts on a fix? Thanks, AlexSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2872099-transmission_kenmore_washer_badTHE TRANSMISSION WENT OUT ON MY KENMORE LAUNDRY CENTER( MODEL # 92702) AND THE PARTS WILL COST ME $300-$400 TO REPAIR. DO YOU KNOW IF THERE IS ANOTHER WASHING MACHINE THAT WOULD HAVE THE SAME TRANSMISSION AS MINE?? TRANSMISSION # 131878410.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2867624-kenmore_model_22702_100_r_nwasher_pumpKenmore model 22702-100 washer won't pump water out; has come to a complete stop.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2839544-washer_not_drain_water_or_spinThe washer does not drain the water or spin. Does the drain work when the spin cycle starts?Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2814984-washing_machine_overflowing_even_setKenmore washer 110.92597210, washing machine overflows, water flow will stop if power is removed.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2469355-washing_machine_wont_drainmy washing machine wont drainSat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2564845-model_23832_spin_cycle_doesnt_spinSpin cycle drains the water out but the tub doesn't spin the water out of clothes. If you manually turn the knob back to the spin cycle seems to work fine. Problem is sparatic......at times it runs thru the cycle properly.Sat, 05 Dec 2009 03:02:05 GMThttp://www.fixya.com/support/t2808379-80_series_heavy_duty_will_not_fillWhen we turn on the machine it starts agitating regardless of the dials position and no water fills. I checked the water lines and they arent clogged or off. any suggestions would be welcome. i am leaning toward the possibility of a needing a...Sat, 05 Dec 2009 03:02:05 GMT