Top 20
Walkera Devo RX701 2.4Ghz 7ch Receiver Questions & Answers
How can i replace a
Spare parts are available for the Walkera line of copters, just go to the web site below to check on the availability of parts for your model. You will need a small set of jewelers screwdrivers for most repairs and a good level of mechanical skill
http://www.walkerasite.com/
2/27/2011 4:00:24 PM •
Walkera Toys
•
294 views • 0 helpful votes
I have a new walkera
sir
jeremydylan2
you have a problem with your rear rotor assembly.
if your rear rotor shaft is broken or the gear is the copter will spin around and around.
or, if these parts are not broken then your trim needs adjustment or, you need to learn to fly and control the rear tail rotor so it does not spin around. Thats your answer. [email protected]
2/18/2011 10:37:59 PM •
Walkera Toys
•
357 views • 0 helpful votes
What could be the problem
When the throttle starts failing this way it is a sign of either a failing contact or batteries. But since you said the batteries are fully charged then we can eliminate the batteries out of the equation.
The throttle contact does not make as much contact as it is supposed to and therefore starts up the rotors and then does not continue giving as much power as it is supposed to.
There could be a power flow breakage or a partial contact somewhere hence the initial startup and the stoppage.
Hope this solution has been helpful?
12/23/2010 11:03:25 PM •
Walkera Toys
•
179 views • 1 helpful votes
Walkera lama 400 just spins
The walkera Lama has a bad gear setup,there are two tiny screws on the topgear which powers your bottom blades one on each side of the outer shaftif these two screws were not properly tighened at the factory or you ran yourLama400 into the ground even if it was at a slow rotation when the bottom impactsthe ground the bolts shear off the outer shaft and you no longer have 100%power to those blades,if your helicopter spins clockwise and you tried everything,this is the problem,replacement is required or you can tear it all downand drill and tap two new holes with new screws,these are machine screwsand are less than 4/40 which is very small.To check hold top gear with twofingers left and right side of gear and turn the bottom blades only,if the bladesturn your shaft to gear screws are sheared offgood luck SK Florida
9/12/2010 8:28:55 PM •
Walkera Toys
•
289 views • 1 helpful votes
Fisher-Price J7485 T-Rex stopped moving
Check Batteries: Ensure that the batteries are properly inserted and have sufficient charge. Sometimes, a low battery can cause the toy to stop functioning.
Switch On/Off: Confirm that the toy is switched on. Some toys have an on/off switch or button that might accidentally get turned off.
Connections and Wires: Inspect the wires and connections inside the toy. Loose wires or faulty connections can lead to malfunction.
Obstructions: Look for any obstructions or debris that might be preventing the T-Rex's movement. Clear any blockages.
Reset: If there's a reset button, try pressing it. This can sometimes resolve minor issues.
Contact Customer Support: If none of the above steps work, consider reaching out to Fisher-Price customer support as below.
https://service.mattel.com/us/ContactUs.aspx
2/17/2024 4:08:00 PM •
Toys
•
35 views • 1 helpful votes
Not finding what you are looking for?