20 Most Recent
GE Profile PSW26P Stainless Steel Side by Side Refrigerator - Page 7 Questions & Answers
How do I unclog a grommet drain tube on, a general
turn off ref. defrost and remove all ice from drain area. you might have to remove rear panel. chip as much ice from drain hole then microwave water to near boil and use a little at a time till water flows freely.
10/15/2013 12:53:37 AM •
GE Profile...
•
Answered
on Oct 15, 2013
Slow to make ice
Look at your water supply coming into the freezer if the water comes from a tap which gets some heat from the sun or other appliances heating the the pipe which will heat the water in the pipe and will take longer to reach freezing point
Ice maker not working
If your ice maker has stopped producing ice completely, check these, in this order:
- It may be turned off. Look for the wire along the right side of the ice maker that looks a bit like a coat hanger. If the wire is in the raised position, the ice maker is turned off. If so, try one of these:
- If your ice maker has a small red plastic lever, lower it to lower the wire.
- If there's no plastic lever, simply lower the wire.
In either case, the ice maker should begin producing ice again. Also make sure that the temperature is 8 degrees Fahrenheit or lower. If the freezer is too warm, the ice maker won't cycle properly.
- The ice maker fill tube may be blocked with ice. If so, melt the blockage using a hair dryer-but be careful to not melt any plastic parts! Also replace the water shut-off valve or water-inlet valve, or both, if necessary.
- The ice maker head assembly may have broken parts. Look to see if the gears are broken. Check to see if the small plastic arms that rest against the ice rake are broken. If the ice maker head assembly is modular and you've found broken parts, you can just replace it.
Water dispenser suddenly not dispensing water
Remove the bottom kick plate . Follow the plastic line about 6" and you'll find a connector . Push in on one end of the connector and at the same time , pull the line out . Close the door and press for water . If no water comes out of the disconnented line , the water valve is probably bad . If water does come out , the line inside the freezer door is frozen . If this turns out to be so , you can lower the freezer temp for maybe days , or , put the food on the door, inside the freezer , tape the light switch down ( to keep the lite off and fan running ) and tape plastic over the freezer door opening so the freezer will continue to work . Reinstall the line back into the connector by pushing the hose firmly into place . Leave the freezer door open for maybe 1 or 2 days for thawing out , going by ocassionally and pressing the water dispensor . Important : lower the freezer temperature slightly to keep line from freezing again . ONLY CHANGE THE FILTER WHEN WATER FLOW SLOWS OR ICE CUBES GET SMALL . The change filter lite comes on by the amount of times water dispensor is used and to make money for the vendor .
Ball bearings on bottom drawer assembly fell out.
If the ball bearings fell out, you have to put them back in one half at a time. The thing that houses it is half the size of the length, so put the top one in at the left and the bottom one in at the right and then you can push them together once they're in.
Not finding what you are looking for?