To reduce the risk of electric shock,this appliance has a polarized plug (one blade wider than the other). This plugwill fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,contact a qualified electrician to install the proper outlet. Do not change the plug in any way.Afin de réduire le risque de choc électrique, cet appareil est muni d’une fiche polarisée (une des lames est pluslarge). Cette fiche ne peut être insérée dans une prise polarisée que d’une seule façon. Si la fiche ne peut être inséréedans la prise, retourner la fiche. Si la fiche ne peut toujours pas être insérée dans la prise, faire installer une priseadéquate par un électricien qualifié. Ne pas modifier la fiche.GENERAL INFORMATIONThe cleaner is designed to pick up dirt and dust particles. Avoid picking up hard or sharp objects with the cleaner toprevent hose clogs.Service InformationThe instructions in this booklet serve as a guide to routine maintenance. For additional service information telephoneour toll free number for the nearest Eureka Authorized Warranty Station. You should know the model, type andserial numbers when you call:USA: 1-800-282-2886Mexico: 5670-6169Canada: 1-800-282-2886If you prefer, you can write to The Eureka Company, Service Division, 807 North Main Street, Bloomington, Illinois 61701,USA. In Canada write to The Eureka Company, 866 Langs Drive, Cambridge, Ontario N3H 2N7. Refer to The Eureka LimitedWarranty for complete service information.DO NOT OIL the motor or the brush roll at any time. The bearings are permanently lubricated and sealed.4Rating PlateThe model, type, and serial numbers are indicated on the rating platelocated on the back side of the cleaner. For prompt and complete serviceinformation, always refer to these numbers when inquiring about service.Model & Type__________________________Serial No. _____________________________MODEL TYPE SERIAL NO.VOLTS AMPS. HERTZSERVICE INFORMATION: 1-800-282-2886THE EUREKA COMPANYBLOOMINGTON, ILLINOIS 61701Thermal Cut OffThis vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the cleaner suddenlyshuts off, push the on/off switch off (0) and unplug the cleaner. Check the cleaner for a possible source of overheating such asa full dust cup, a blocked hose or clogged filter. If these conditions are found, fix them and wait at least 30 minutes beforeattempting to use the cleaner. After the 30 minute period, plug the cleaner back in and push the on/off switch on (l). If thecleaner still does not run, then take it to a Eureka Authorized Service Center for repair.
Guru