http://www.fixya.com/support/p11941-genie_company_gv150_wet_dry_vacuumSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comTue, 22 Dec 2009 18:33:10 GMT80http://www.fixya.com/support/t3411279-not_any_suctiondOES NOT HAVE ANY SUCTIONTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t2009831-use_genie_wet_dry_vac_or_without_paperhey, so I have a Genie wet/dry vac model PB15/120V/60Hz/6.5 Amps which I just got given my my uncle-- here's the thing, there's a small paper liner inside and I'm afraid to use it for sucking up liquids because of that. SHould I remove the bag and...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t191492-manual_genie_vacuumi need to take vac apart to repair on/off switch not sure how to dissasemble it. model PR0600QTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t400909-genie_wet_dry_vacuum_replacement_partWhere can I get a replacement hose for the Genie We/Dry vacuumTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t227489-windsor_sensor_12_vacuum_no_poweri know I have power down to the last quick disconnect in the housing base. I take off the cover today and I have circuit boards, capacitors, ect., ect. I have a digital meter. Is there anything I can check and how to check? As in circuit board, burnt...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t235496-shampooing_carpetdon't know how to hook up carpet cleaning attachmentsTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t236618-bissell_630_wI am having a problem with my new vacuum. I used it twice and I no longer have jun going into the pail. I cleared the lower suction tube and cleaned the filters and stillnothing going in. I have only had it for about a month and bought it t Wal-Mart....Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t232886-kenmore_canister_model_116_25512_startVacuum cleaner only runs when hose is inserted into Power Mate attachment, and only when switch (located on the hose unit) is set to "carpet." Does not turn on when set to "floors). When hose is not hooked up to the Power Mate, I can't turn the unit...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t246371-kirby_g6_shampooerI need instructions as to how to put the shampooer together and if there is a way to make it compact enough to do stairs. ThanksTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t247223-self_propelled_wind_tunnel_vacum_willWhy doesn't my self propelled vacum not move when handle is released,when both belts are intact and roller brush moves when turned on.?Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t251981-dirt_devil_vacuum_belthow do I change this belt?Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t254405-remove_vacuum_roller_offHow do you remove roller. Powerline Limited Editon Model #4352 ThanksTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t260486-pullman_built_in_vacuum_cleaning_systemhaving problem with lose of suctionTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t263819-power_consumption_refridgeratorsHi thereI am in the process of buying a generator for power losses (I live in a rural area) to ensure the Fridge and Freezer are kept running. I want to assertain the power (wattage) of my Refridgerators so I can ensure I buy an appropriately sized...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t268160-windtunnel_beltTell me how to install pleaseTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t282386-hoover_hush_series_central_vac_turnThe central vaccuum will not turn on from the wall (hose), it has to be be turned on at the canister.? All the electrical connections are correct and nothing seems to be loose.? I had this problem when I installed it and I can't remember what I had...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t284672-cleaning_bissell_powersteam_cleanerThere is a clear plastic cover on the steam cleaner that attracts the carpet fuzz and when I finished cleaning the carpet I want to clean it out but can't figure out how to get to it.Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t286004-open_hoover_dm4526_change_beltMy Hoover vacuum DM4526 has a broken belt and I can't open it u enough to get the new belt on. Any ideas? Many thanks PenniTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t289883-nylon_washers_bissell_9200there are two 4"dia. washers on each side on the pivot point where the handle is attached to the base these washes have slots cut into them do these slots need to line up in any particular fashion when the handle assembly is reattached to the base?...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t304313-vacuum_cleaner_repairLOUDER THAN USUAL MOTOR BAG EMPTY FILTER CLEAN CAN'T REMOVE TOP COVER TO CHECK MOTOR WORRIED THE MOTOR WILL BURN OUT SUCKING IS WEAKER THAN USUALTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t305480-bad_motorI have purchased two of the Kenmore direct drive beltless systems with Progressive systems. The first died after a year, the vacuum motor start making a grinding noies. I pulled the side HEPA filter and could see a fine coating of graphite like dust....Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t305828-fantom_fm760power to motor goes on and off when the handle is moved up and downTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t287105-kirby_sentria_not_distributing_shampooOur new Sentria is not shampooing correctly. It is dumping the soap and water in the center only, not a full width distribution. I cleaned filters like the manual says once before and it worked. Not this time. Any ideas?Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t312011-eureka_4467av_upright_vacuum_userdo you have one you can email to me.. I am having trouble trying to figure out how or where to open my vacuum up from to feplace belt kuntripoolgal@yahoo.comTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t322583-hoover_upright_windtunnel_isntit has suction, it just wont go foreward and its hard to push. i opened the bottom part and saw that the v shape belt was loose but i dont know if thats all i have to do. i cant find a manual online for u6470-900 hoover. should replacing that one...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t324266-mach_5_hoover_turns_offI have a hoover mach 5 bagless that I purchased last year. Recenlty it began to shut off after a short amount of use. At first I thougth it was a short, but after awhile it will start again only to shut off a few minutes later. Is it overheating? If...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t329930-eureka_deep_steam_cleanermy deep steam cleaner stopped sucking the water up. any ideas whyTue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t331544-black_decker_hand_vacuum_chv_9600_mikeHi. We own a hand vaccum ( Model CHV 9600 ). The charger light doesn't come on sat the back of the unit. The unit seems to be holding charge, however. Is it possible that the light is malfunctioning and that the battery pack and charger are o.k? It...Tue, 22 Dec 2009 18:33:10 GMThttp://www.fixya.com/support/t326702-craftsman_snow_throwerMY BLADE STOP TURNING, WHAT CAN I DO.Tue, 22 Dec 2009 18:33:10 GMT