http://www.fixya.com/support/p1185051-hayward_100_000_btu_heater_ag_pool_spa_hSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comThu, 03 Dec 2009 07:36:20 GMT80http://www.fixya.com/support/t2698994-heater_also_knocks_when_startingMy Alkalenity has been really low and tried all summer to raise with no success. I'm hoping it's not rusted out from the inside. The knocking sound almost seems like particles are running through the heat exhacher. Any ideas to help or do you think...Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2576163-heater_starts_up_operates_about_5_min_orI cleaned out burners for possible spider webs, it almost seems like the thermostat is being satisfied. Ijumped out the 2 wires on the back ot the dial only to get the same resultsThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2408839-hayward_model_h100id1_pool_heaterI open the pool this yr and the heater makes a nocking nosie runs for about 2 min then starts nockingI have 30lb of propane left from last yr. do In need to fill the tank with new propane or dose the burner need to be cleaned?? Please help Thanks...Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2379854-new_heater_fireI have used it twice in the last couple of weeks & today it would not start.It has power at outlet & nothing comes on.Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2331420-problems_hayward_100_000_btu_heaterMy new Hayward heater has electronic ignition and does not spark. The blower fan works bot no spark. What could be wrong?Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t1143914-solar_heater_controlercant set roof tempThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t1334540-heater_temperature_control_buttonsHi, I have a hayward h250 digital heater, the buttons to raise and lower the temperature are not working. The current temperature is displayed and the heater fires when I switch to spa mode but I have no reaction when I press the up or down...Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t1474241-solve_ffl_fault_r207a_spa_heaterwe just replace the boardThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t1519190-older_jucuzziI have an older jucuzzi spa. Model number z140. I had one of the primary wires burn through some time ago. I repaired this and the spa ran fine until yesterday. It quit running, heating, just plain quit. I checked it today and found one of the...Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2048570-top_element_comeDoes the top element come on first? I have changed the temp sensors on top and bottom and the bottom element. I do not get 220 volts at the lower elementThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2398160-pool_heater_pilot_works_but_no_heaterhave a laars hot shot model LHS pool heater. Pilot lights fine and stays lit, heater will not fire up. What do I check next or replace?Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2362964-heater_will_not_fireHeater will not fire. Will stay lit when both TH wires are removed. New pilot assembly and gas valve. Thanks.Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2609480-when_press_massage_button_tripswhen i press the massage button it trips my electric and turns offThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2609504-layz_spa_pumpthe heater wont work on my layz spa everything else works but wont heat upThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2623319-light_pilot_lightlight pilot lightThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2710085-hot_shot_heater_pilot_satys_but_will_notHot shot heater pilot satys on but will not igniteThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2733656-lochinvar_water_heater_model_ltn040gLochinvar water heater model LTN040G. Can't move dial from "on" past "pilot" to "off" to relight. Seems like there must be something I need to do to make it move, but can't figure it out.Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2744696-no_error_codes_but_no_gas_burnersNo error codes, but no gas to burners. Heater has not been used for nine months. Gas valve open, igniter working, fan works and control panel seems to function properly.Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2750903-mini_max_plus_150_fails_fireevery morning we have to reset power to get boiler to fireThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2814716-coates_pool_electric_heaterWe have A Coates pool electric heater and the heater poped the reset twice. How do you test for bad elements.Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2814797-error_code_eo5the heater will not stay on-- it stops and shows an error code E05Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2870249-buy_new_thermostat_lay_z_spawhere can i buy a new thermostat for a lay z spa series 2Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2915726-water_leaking_out_opening_holdingWater is leaking out of an opening that holds what looks like a thermo bulb on the water inlet manifold. The probe sits in an open (now that is) tube on the top of the manifold. Is there a fitting or gasket that is missing?Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t2984282-sundance_spa_replaceI have a sundance spa that I had to replace the heater in. When I replaced it, the panel showed a ---- indicating a problem and the hot tub deactivated so not to cause damage. I also replaced the sensor in the heater that plugs into the circuit board...Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t3171371-spa_heater_saying_spa_126_degreesmy spa heater is saying the spa is 126 degrees on the digital screen. so it wont heat. it has never done that. How do i fix itThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t3175088-spa_power_but_will_not_allow_breakerMy spa has power but will not allow the breaker to stay on after we drained it and replaced water. I have been told there maybe air in the system how do we get the air out?? JimThu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t3064547-error_message_eo5_pentair_mini_maxError Message EO5, have had everything possible replaced or checked, it refuses to stay on.Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t3209699-pentair_minimax_heater_wont_firemy pentair minimax heater wont fire. The ceramic ignighter appears to be good and has continuity. So does the thermal fuse. The only thing that is puzzling, is when I pull the lead off the control board that goes to the thermister and put it back on,...Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t3247514-make_high_limit_trip_only_nightWhat would make the high limit trip only at night on a Lochinvar Copper Fin water heater?Thu, 03 Dec 2009 07:36:21 GMThttp://www.fixya.com/support/t3258566-heat_exchanger_knockingheat exchanger knocking there is plenty of water going in and out of the heater but not enough going into tjhe heat exchanger It is for a spa the model # h100id and I don"t think it is a scaling problem probably an auto bi pass problem the heater...Thu, 03 Dec 2009 07:36:21 GMT