20 Most Recent Bosch SHV68 Built-in Dishwasher Questions & Answers

Is it getting hot? Is it waiting for rinse aid? is it draining ok? Where is it stopping? What is is doing that works ok? You need to eliminate possibilities.
I hope I have been of help but please do not hesitate to ask if you have any further questions.

I appreciate your vote if you appreciate my reply and remember, even if you don't vote for me a please and thank you goes a long way

There are two main ways to remove it.

• There should be screws on metal trim the side and or bottom of the dishwasher door. Take those out and it should come right off.

Or

• There are screws on the back of the door screwed in to the front of the door. Remove the screws and it should come off.
  

Now this is say IF it was installed properly and not clued or screwed on by just anyone.

Good luck. I hope this helps.

Hi,
Here is a tip that will help you to find out why water will not come into thedishwasher...

Dishwasher Trouble No Water entering Dishwasher

heatman101

Hi, I have a coulpe of question's to start off, how much water is left at the end of the cycle we're talking about and how long does a typical cycle last ? 2-3 hours or 2 hours & less. Has there been any changes recently with plumbing or hot water tank etc ?These are just a couple of factors which will go a long way to finding you a solution. I look forward to reading your reply. Macmarkus :)

I believe it is an incoming water temperature sensor. Have you recently changed the temperature of your hotwater tank? You may want to contact Bosch regarding this. You may also have a problem with the internal water heater.

Hi Phil, First I would check you drain ... Make sure it is clean, clear and drains fast...if you have a garbage disposal make sure it is also clean...also check that the drain hose is above the bottom of the sink... hope this helps you...

check the dishwasher electrical box connection. remove kickplate. box is on r/h side. remove cover. you will probably find the wires and marettes burnt. simply repair the wires. this happens from time to time if the connection is not the best. hope that helped

this is defenitly a repair for a certified bosch technician. the tub must be removed from the base to complete this repair. DO NOT ATTEMPT.

I had the same problem. I took out the filter and cleaned it, scooped out as much water as I could and poured some sink unblocker into the bottom of the washer, followed by some hot water. After leaving it a while I took the plastic mesh cover off, and removed and cleaned all the bits I could (will be different on different washers). Then I put it all back together and ran a quick wash, and it worked. I did a couple more washes with it empty in case there was any cleaner still lurking. Result - one unblocked (and sparkly clean!) dishwasher. Hope this helps!

That is just saying the Child Lock (CL) has been activated.

Deactivate the child lock ' Bosch

Bosch Home https://www.bosch-home.com > ... > Get support 1. Press and hold the start button for three to five seconds ... When the child lock is activated, there will be a message "CL" in the display and all the washing ...

Bosch dishwasher child lock problem

Bosch-home.co.uk https://www.bosch-home.co.uk > ... > Dishwashers Hold down the lock button for three to five seconds. You should hear an audible beep and/or see the symbol disappear. The child lock is now deactivated.

What does CL mean on a dishwasher? And how do I fix it?

Quora https://www.quora.com > What-does-CL-mean-on-a-dish... This code means that the CHILD LOCK or CONTROL LOCK feature has been activated. When activated, all buttons will not change except the washer's door and the ... 9 answers · Top answer: First, look on your dishwasher to find a label that shows the manufacturer and the model number. ...

How to turn off the CL on the display of a bosch dishwashe...

JustAnswer https://www.justanswer.com > Appliance Repair Oct 28, 2010 - You should just be able to just turn the power button off, then turn it back on and the CL should be gone. 1 answer · Top answer: Hello, and thank you for using this service. I'll be helping you with your ..https://www.youtube.com/watch?v=Xr4DBwACUW4

the unit could be un-level

YOU CAN ONLY LEARN TO ATTEND TO IT WHEN IT SOUNDS . THEY HAVE NO FEATURE TO TURN IT OFF OTHERWISE

HiPump-out not accomplished in normal time.Check the drainage and replace or reposition the drain hose,Clean it out by running the disposer.

This is the parts schematic that shows all the parts and where they are located. The noise is either something stuck in the pump or a dry bearing. https://www.searspartsdirect.com/model/25b4iqte9a-001794/bosch-she58c02uc-50-dishwasher-parts ..