20 Most Recent Bosch 24 in. SHU43 Built-in Dishwasher - Page 3 Questions & Answers

sounds like the pump has a blockage in the machine or if there is separate pump to drain as opposed to the one that pressurizes and washes your dishes it may be faulty some machines ( not sure about this one ) have two a high pressure pump for washing and a low pressure one for emptying . Some machines have a system that switches the pump from wash to outlet and this is a usually a relay to an electr'o mechanical tap ( it directs water to jets or out to drain ) all of these systems are controlled by the Programmer and should this go faulty many problems can occur. I suggest you seek help from your local repairman, this type of fault will probably be very familiar to him

Could you elaborate on this please? Do you mean print on the fascia? if you mean digits in the display, some models only display the delay to start time and not the wash time. Refer to the user manual for the features of the product and if it is not working as it should please be more specific with your problem. Thanks.

You will need to replace the Drain Pump Motor Assembly Bosch Part Number:AP2802385. Most Bosch dishwashers are relatively straightforward to work on. However, it you are not familiar with their disassembly and reassembly, you should take clear pictures of every part or wiring connection before you take it off or disconnect it. This will be invaluable when reassembling the dishwasher.

I believe you have found the code sequence as shown in your additional information post. Please clarify if you are looking for anything additional.

These have a instant water heater or circulation pump with in built heater. It could be the relay on the control module burnt out. Either that or possible water pressure / level issue's or pressure switch issue.

The control panel is fixed to the stainless steel inner panel. You will need either a phillips or a T20 torx screwdriver depending on what fixing have been used. You will need to take out all the screws which line up with the control panel plastics. There is usually one in the left and right sided at the top of the inner frame also. The screw by the door lock along the top will have to come off if it has one. Looking at this unit it is an older design so it should do. Now sometimes you will need to loosen off the screws holding the front decor panel a bit, I normally loosen the top and middle ones enough to free up the control panel a bit to jiggle it out of position. It is easier to take this decor right off and get the control panel out but takes longer. Now if you have the unit I think you do the plastics on the control module will be quite brittle so be careful not break it if you need to check it for some reason. There are a few plastic clips around the module which clip it into the metal frame. The metal frame clips into the display fasia. You should see the clips round the edge of the metal frame which are tricky to get off sometimes. Once you have the display plastics separated, then you can un clip the module from the metal frame. As I said be careful especially of the buttons. Also be careful not to pull on the cables to much if removing witht he decor panel still on the unit. The edge of the metal may cut into the wires. As with any work on electrical equipment, please stay safe and make sure the unit is unplugged.

Look for the automatic shutoff switch underneath the machine left side , hard to find. might have to take machine and tilt it way over to find. just push switch up to reset.

All DW that I know of will have water sitting at the bottom.. it keeps the seal moist..check your drain line make sure its clean and not clog... when your DW goes into drain listen to see if its drainning like it did when you first used it... I'll check back later..

Do you have the serial number? Bosch had a recall on there circuit boards. If you fall under recall they will pay to have the board replaced or offer you a percentage towards purchase of a new dishwasher.