http://www.fixya.com/support/p117056-bosch_axxis_wta_3003_electric_dryerSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comWed, 02 Dec 2009 13:44:24 GMT80http://www.fixya.com/support/t2020368-best_way_replace_drum_belthow to replace drum belt on compact Axxis DryerWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t206972-apart_kenmore_front_load_dryerI have a Kenmore dryer, which the model number in my manual says it is a 417 and the number on my receipt is 26 83042. I have problems with clothes getting stuck between the drum and the front case and torn or shredded. Recently a bell from my...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t211796-kenmore_washing_machineinstead of the water staying in the machine to start the wash cycle,it's going out before it fills.what do you mean valid product? This is what's on the machine.Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t211814-gas_only_comes_couple_cyclesI took the panel off the front and cleaned about a 1/2 inch of lint off of the inside. yikes! There was actually a layer that looked like it had been smoldering. I can see the igniter working and for the first two or three cycles the gas comes on...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t214286-neff_condenser_t_dryer_no_heatAs above! All functions appear to be working normally but with no heatWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t214448-dryer_stopped_workingFairly old but reliable electric dryer that just stopped working. There is a buzz when I push start button.... but nothing else. I checked the belts. They look fine. Maytag DE410Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t216248-maytag_gas_dryer_stay_litI have a Neptune gas dryer. It will light up, but only stays lit for 5-10 seconds. The dryer is still running and I hear a click sound like it is wanting to light again but doesn't. If I stop the dryer, then push the start button, it will...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t220664-loose_drum_support_feltI notice that the dryer was making noise with the turning of the drum. I opened up the top of the dryer and found that the felt strip that the drum rides on has come loose. It appears that plastic studs that were used to hold it in place have...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t224525-drier_problemsWent to use it and nothing. It's plugged in knopw light ,timer ticking nothing. Is there a fuse or a reset bottom I'm not seeing? HELP!! RickWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t227654-dryerdyer heating elment comes on then clicks goes off then comes onWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t239498-clothes_not_getting_driedMy dryer is not getting clothes dried. I see a light on inside and it feels hot. But nothing is getting dried. What do you think it is?Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t239618-tumble_dryer_not_drying_clothesIts an LG - its working and spining but no heat so clothes stay wait and no moisutre is taken from clothes?Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t243194-dryer_drum_issuesI have a Kenmore electric dryer. When I turn it on, it heats up and blows, but the drum won't turn.Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t247664-196_degree_non_resettable_thermal_fuseModel # LER3624EQO (or) 0 (Last character is a letter O or numeral 0.? I can't tell for sure)? This is a front loading electric dryer approx 10 yr old.? Dryer will not run, timer works and can be herd ticking, stops when front door is opened.? Start...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t250199-connection_new_circuit_board_creda_tumbeI have purchased a new cicuit board as the other one burnt out due to lying on the drum whilst operating. I have now purchased a new circuit board. Can you please send me a picture or confirm which 3 wires attach to which 3 places on the circuit...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t259190-ge_profile_harmony_dpgt750ec_electricI have basically been through all the troubleshooting and diagnostic modes...the dryer comes on...the exhaust is working fine...it is heating...diagonostics all checked out ok...it is getting good voltage...I'm at a loss..Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t264773-amana_dryer_le8107w2Dryer stops running after a few minutes seems to get to hotWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t265583-parts_old_inglis_dryerLooking for parts for 2 old dryer inglis model JO94580DR 1 and Lo89080 door switch for bothWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t269813-kenmore_gas_propane_dryerMy Problem is this - Our dryer was drying one load, then the next load was still wet. I checked the vent for obstructions and found none. The igniter would not glow, so I changed it. I have cleaned every inch of the dryer and still nothing. I checked...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t272276-maytag_dryermy dryer flame only comes on once or twice during the cycle and then the flame quits.Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t274217-dryerI purchased a LG washer and dryer from Home Depot in Manhattan, Kansas. When we picked up the washer and dryer they were in pristine boxes therefore not checked for damage. Upon arriving home with the appliances we discovered that although the dryer...Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t274943-dryer_will_not_drydry runs and drum rotates but will not dryWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t277499-replacing_control_knob_spindle_tumblei HAVE A WHITE KNIGHT 3KG LOAD TUMBLE DRYER AND THE CONTROL KNOW HAS COME OFF AND THE SPINDLE WHICH TURNS IT HAS ALSO BROKEN CAN I REPLACE IT AND FIX IT MYSELFWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t277562-indesit_is60v_dryeri dont know how it goes on and it seems to be a bit big i know its the right one. can some one help please i really need my dryer o ya its an indesit is60v.Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t279347-dryer_powerwhen pushing my power button on my dryer the motor sound like its getting power but wont turn on i replaced the thermal fuse which solved the problem once before but did not fix it this time thanks fredWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t284861-hotpoint_dryer_tc71pWhen replacing the cut-out kit, how do you know which one is the auto reset and which one is the one shot. Thans GlynWed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t286001-broken_belt_hotpoint_vtd65_tumble_dryerjust wanted to know how to replace the broken belt everything else on dryer works just need to know how to go about replacing the belt thanks.Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t286403-hotpoint_dryermy dryer was running, then quit. it will not start, repalced timmer switch, still wont do anything. belt and drum both turn by hand. outlet has power.Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t287024-start_knob_broken_offI have a GE model DCLR333ETOWW dryer that is great, but the start knob got broken off in a move. Where can I find a replacement part? Thanks!!Wed, 02 Dec 2009 13:44:24 GMThttp://www.fixya.com/support/t288887-white_knight_767_tumble_drierhi, my tumble drier is overheating i think... yesterday i accidentally dried a door mat with a rubber trim in my tumble drier. the tumble drier cut off after a bit, and it wasn't until later that my boyfriend realised that i had dried the mat, which...Wed, 02 Dec 2009 13:44:24 GMT