http://www.fixya.com/support/p1146508-northern_tool_lawn_mower_battery_12_voltSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comWed, 02 Dec 2009 10:52:07 GMT80http://www.fixya.com/support/t996114-poula_pro_mowerPoulan Pro Mower after 5 minutes looses power it wont go forward or backwards,Blades work fine after 2 hours cooling it runs for 5 minutes Engine works fine.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1033184-oil_leakI have a model 289707-0154-01 12.5 hp engine that is leaking oil from the bottom of the engine. looks as if it is running down the crankshaft.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1076674-directionsto_put_new_belt_murray_mowerNEED TO KNOW HOW TO PUT NEW BELT ON LAWNMOWER DO NOT HAVE MANUAL!Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1125714-victa_lawnmoweris the one with the plastic carby could be 20 years old when it goes it has grunt but wont start has spark i have put fresh 2/ in it but still no go please help the lawns are growingWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1154899-tecumseh_4_5hp_small_engineHow do I align the camshaft/flywheel when reassembling? And the small plastic "banjo looking piece" on the bottom of the camshaft,which I assume is the oil pump for it,is tapered on one side,does that side face the bottom or up towards the camshaft?Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1330834-re_assebble_engine_375_sprinttook engine appart to change the piston rings ,and the engine got knocked over.....timing wheel and valves fell out. can you help joanWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1569504-set_camshaft_timing_in_honda_mowerset timing of camshaft gear to drive gear on crankshaftWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1604789-electric_self_start_problem_bikeCan anyone help me out for the problem with my bike self start. it is new unicorn and its self starting mechanism is not working.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1622754-need_tune_up_old_lawn_mowerneed specs on spark plug gap, setings for idle and rich/lean screws for a kawasaki engine #fc150v176157 john deer lawn mower JD906 another number stamped on engine was 890408 thanks-- codyWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1684184-20_amp_fuse_blowingfuse blows intermitenly then the mowers fine.usually happens after half an hours use,yesterday blow 6 fuses one after another.the fuse was blowing with the machine switched off,after a ten minute rest the mower worked fine again.the mower is 2 years...Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1685154-honda_hr2160_starts_but_cutts_outengine starts but cutts out it also cutts out when i engage the rotary bladeWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1739199-want_replace_pull_cord_lawnboyI want to replace the pull cord on my lawnboy lawnmower which also has electric start. The pull cord broke and the battery for the electric start is no longer functional.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1750594-pull_start_assembley_unit_apartthe pull start assembley unit is apart how do i put it back togetherWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1798869-when_start_mower_smoke_coming_fromWhen i start the mower, smoke is coming from the vent on the side and a little oil splatter. I have checked the oil sump and it had enough oil. Can't find the manual.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1812054-cutting_outHONDA IZY 465 PDE CUTTING OUT , HAVE CLEANED AND GAPPED PLUG STILL CUTTING OUT ?Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1819539-sears_craftsman_riding_mower_willI have Sears Craftsman riding mower and it will run for about 15 minutes and then starts choking out and will cut off. I have replaced the fuel filter and had carb cleaned. Still having the same problem.What should I tey next?Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1825999-engine_runs_2_3_seconds_stops6.75 hp Briggs and Stratton engine on Sears mower. I prime it with push buld. it will start for 2-3 seconds then stop. All new gas. cleaned air filter. still just stops.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1826004-not_getting_fuel_lawnboymower is not getting fuelWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1839864-craftsman_lawn_mower_not_run_withoutI have a Craftsman lawn mower model # 917378760. I haven't used it for 3 years. This morning, I add gasoline and checked the oil. I pumped the red button couple times. I ignite the engine. But, the engine get dead. I finally found out that I have to...Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1840954-separate_conrod_crank_get_piston_out_vit has somthing that looks like a push pin but im not sure how to get it out so i can rebuild my victor push mowerWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1846314-mower_will_turn_over_but_startcharged the battery, clean battery terminals but still won't start.......yard-man bugWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1857234-replaced_drive_belt_linking_twoI have replaced the drive belt linking to the two blades on my Rally ride-on lawn mower (92cm 5 speed 11.5 hp) and they are now cutting effectively. The problem I have is that the blades are still driven round when I try to disengage them using the...Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1857624-starter_rope_brokeI have a craftsman lawnmower model 917.377292 and the starter rope broke. How do I replace it?Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1881599-john_deere_model_14sb_lawn_mower_repairreplaced drive belt and reinstalled blade clutch. blade clutch is now building a tremendous amount of heat. seems to be engaged even when disengaged.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1885344-rope_not_retractI replaced the starter rope for the lawn mower. First problem was I didn't pay attention to the original configuration. When I open it up the tension spring flew off. I got it back on but don't know if it is on the right way. When I pull the rope it...Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1888974-1_solution1 Solution for ''husqvarna 55R 21 HVC Problem with engine surging (RPM'S )Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1890549-high_rev_dying_lawn_mowerMy mower will start after I prime it with the bulb primer, 3-4 plunges, and the engine will rev very high and then slow down,sputter and then stop. I have to prime it again to get it to run, but it will not stay on. It sounds like it is not getting...Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1898699-self_propelled_will_not_workI have a Honda HarmonyII model # HRZ21TDA about 3 years old. self propell will not pull. if I litf up wheels off the ground the wheels will spin ? Thank you for any info.Wed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1908419-looking_operators_manual_6_horsepowerLooking for operator's manual for 6 horsepower Craftsman LawnmowerWed, 02 Dec 2009 10:52:07 GMThttp://www.fixya.com/support/t1911369-need_wiring_diagram_kawasaki_fc420vI need the wiring diagram for this engine, a friend said he could fix my engine that lost spark,but after taking the wiring apart he said he could'nt figure it out .So when I went to pick it up he had cut wires and removed a couple of componets and...Wed, 02 Dec 2009 10:52:07 GMT