20 Most Recent Garmin NUVI 360 GPS Receiver Questions & Answers


here is a screen on ebay

Garmin NUVI 360... | Answered on Jul 14, 2017


No, there are no free maps for that model.

Garmin NUVI 360... | Answered on May 02, 2016


try putting sd card back into a pc and check that the write protection is turned off. also if it has a write protection switch on the side of it it will need to be off. failing this. you may need to check what format the sd card was formatted in . it will need to be ntfs formatt not fat32. if it is fat32 ,save whats on it re format to ntfs then reload your files. try again.. cheers Phixxer.

Garmin NUVI 360... | Answered on Jul 04, 2014


jon battery is inside, may have flat charge, try recharge waiting more;
jon battery protection recharging circuit, may be broken or battery pack loose minimum voltage to be recharged, about 2,5 volts.
SAFETY recharge range of jon batt. is 2,8 to 4,15 volts.

Garmin NUVI 360... | Answered on Apr 23, 2014


Connect the unit up to a PC and try deleting some of the unused text-to- speech (TTS) voices. Keep only the ones that you need. Delete any unused photos or MP3's...and also any unused vehicle icons on the unit. When the unit is booting, it loads in all of the vehicle icons allowing you to change the selected vehicle, so this too uses up valuable memory.

Garmin NUVI 360... | Answered on Apr 11, 2013


You can get details of how to update your garmin nuvi satnav maps at http://www.fixya.com/support/r5628920-update_garmin_satnav_maps

It's a good idea to back up your satnav favourites to your computer. You can find details of how to do this at http://www.fixya.com/support/r8422587-backup_restore_favourites_garmin_nuvi

Garmin NUVI 360... | Answered on Mar 24, 2011


1.Try to reset your gps device..
Here's How ...please watch this video ...

2.Use the Garmin web updater to update your gps device ..
Please click on the link below:
http://www8.garmin.com/products/webupdater/
3.If the problem still occurs ,the signal issue might be caused by poor solder joints. It's caused by a defective part.
The defective part needs to be replaced with a higher rated part. This type of repair returns the unit to full functionality and allows the unit to properly switch between the internal and external antenna as it was intended to do by design

Garmin NUVI 360... | Answered on Mar 15, 2011


With the unit off......... plug in your nuvi with the USB cable to your computer

Go to www.MyGarmin.com

If you haven't registered your unit yet, do it there

It will then detect your unit for any updates

Garmin NUVI 360... | Answered on Oct 23, 2010


Few reasons this may occur, most you can do something about.

1) Make sure the battery is fully charged before commencing journey ( USB or mains charger)
2) Plug the GPS in after the engine is started to protect the delicate SIIRF chip.NEVER Start engine with GPS connected.
3) Ensure you have a clear uninterrupted view ofd the sky. Place the GPS closer to the windscreen if poss and away from Phone..stereo or other electronic devices

4) If your unit supports it get an external antenna to plug in ( magnetic base mouse antenna)

5) check BAUD and PORT are set correctly.

Please rate my help++++Thanks for using FIXYA

Garmin NUVI 360... | Answered on May 29, 2010


You will have to contact Garmin support and have them change the registration which is matched to an e-mail address and the unit serial number. Device registration on Garmin's site is a "security feature" for two reasons: 1: People can buy lifetime map upgrades for a particular peice of hardware, and 2: GPS units are very high-theft devices.

E-mail support with the details (proof) of your purchase and ask them to change or reset the ownership information for your unit's serial number.

Garmin NUVI 360... | Answered on Apr 04, 2010


Press and hold the antenna signal strength icon on the display to bring up Satellite reception information. This will show you what, if any, satellites are being tracked. It will also tell you if you're in DEMO mode, in which case real satellite signals won't be used for the position.

Additionally, you can check the hardware by using the built-in hardware self-test features by pressing and holding the battery icon. Examine the information presented on multiple pages by pressing 'next'. Look for the hardware TEST button and press it. Wait several seconds for results.

These two steps should at least tell you where the problem is. If you ARE getting Satellite signals but they aren't being used by the hardware, you may need to reset your unit. Also check for firmware updates by using the Garmin Update utility available on their web site.

Garmin NUVI 360... | Answered on Apr 04, 2010


Going to say it's rf interferance that makes things go crazy. If the gps unit works fine witrh the antennae in the down or closed position then leave it like this. If not you might have to try moving the unit around to different spots on your dash and hope that one of them will work. Oh as to the reason, the plastic is a little thicker on the back of the unit wqhere the antennae is and the antennaes power when it is up is able to radiate a little better since the top of the antennae is the part that gets the power.
Hope this helps

Garmin NUVI 360... | Answered on Mar 12, 2010

Not finding what you are looking for?
Garmin NUVI 360 GPS Receiver Logo

57 questions posted

Ask a Question

Usually answered in minutes!

Top Garmin GPS Experts

Marvin
Marvin

Level 3 Expert

83772 Answers

Jean-Luc Steffann

Level 2 Expert

83 Answers

Steve

Level 3 Expert

3289 Answers

Are you a Garmin GPS Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

nuvi Garmin

  • nuvi Garmin

Most Popular Question

garmin nuvi screen cracked

  • GPS
Loading...