20 Most Recent
Samsung SW62ASP Top Load Washer - Page 9 Questions & Answers
All of my washing machine's "FUnction" buttons do
Change the program controler unit /the board if you need to get access to all the programs.
Remove the controller unit and make sure that the connectors are tight. Make sure the water level sensors , the door switch is working.
If there is no result the program controller is a suspect.
My Samsung washing machine won't
I washed a bath mat and the dryrot from the back came off in the washer. The washer stopped spinning and won't drain now. I checked the hose to see if it was clogged, but appeared to me clear. Sounds like motor is trying to spin but won't move.
De error code on samsung topo loader stops working
0E - OVER-FLOW ERROR
Over-Flow error occurs when the water level is too high. It can be cleared by turning POWER switch OFF. Water is drained prior to POWER switch OFF. The tub is drained for 2 minutes if a frequency of more than 25 KHz is detected.
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question
Doesnt dry shows dE when
Hi,
dE = drainage error,
empty the filter, check pipe outlets are clear , check the pump
Thank You
Rattling sound and vibration while
The spin bearing or basket drive may be worn or seized. These components allow the inner tub to spin freely inside the outer tub. When this is the problem, you usually hear a loud sound during the spin cycle. The other possibility can be faulty motor causing the bearing to rattle/.
Check out both the motor as well as spin bearing.
You can get required parts from www.repairclinic.com
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation.
Hi there, I have a Samsung top loader and have
Surely you are in a better position to work this out than us! Try ising a hose with a rubber cup connection to fot to your tap.Perhaps even boild up a large container of hot water and carry it to the machine!
Thanks for using FIXYA
Error on screen if load bigger - DE
Hello,De error refers to "Door Error".
You do not need to buy a new machine. You can fix this.
Look at the below mentioned link
http://lgknowledgebase.com/kb/index.php?View=entry&EntryID=799
Thanks
Cold water no longer fills the drum
Hi,
It seems more likely an Water Inlet Valve.
The Procedure to Test :-
http://www.partselect.com/washer+test-water-valve+repair.htm
For Solenoid, check the below Links :-
http://www.appliance411.com/faq/test-water-valve.shtml
http://www.appliance411.com/faq/test-solenoid.shtml
Let me know, if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
Samsung SW65ASP2 top load washing machine only
there may be an obstuction at the wateer inlet valve turn off your water and remove the hoses and check for anything that would be restricting the water flow if this does not work you may need to replace the inlet valves.
Black rubber deposits in wash tub
If that is the same color as the rubbber boot or ring that connects the basket with the door then the boot, it's deteriorating, maybe you are using too much detergent, any way the boot needs to be replaced
Not finding what you are looking for?