http://www.fixya.com/support/p102061-sharp_r_1874_850_watts_convectionSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comWed, 23 Dec 2009 15:30:04 GMT80http://www.fixya.com/support/t3269123-replace_th_display_bulb_ovencan i replace th display bulb of my ovenWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t3243124-need_specs_sharp_r_1874fneed specs on Sharp R-1874FWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t3243094-no_manual_only_model_numberi have no manual only model numberWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t3023683-sharp_r_1874_over_range_oven_quitMy Sharp R-1874 over the range oven quit working. Is there a fuse?Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1780174-every_59_seconds_unit_stopsno matter what cycle or how long we set the unit to run, it shuts down every 59 secondsWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t2499878-anybody_tell_me_in_ukHi - Can anybody tell me where in the UK I can source parts for a faulty Sharp R-1874 Convection Oven - The US based suppliers say they cannot supply to overseas customers! help!Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t2932792-r_1874_shuts_down_after_59_secondsHad tech check and said that the damper motor was bad. I ordered and replaced the motor. The motor does cycle and open and close the damper door, but the unit still shuts down after 59 seconds. What is the purpose of the switch that is next to the...Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1689183-all_88888s_display_after_power_outageall 88888's on display after power outage can't program anything,Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t2622486-internal_fusewhere is the internal fuseWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t231344-sharp_r_1874_shuts_off_after_59_secondsMy microwave/convection shuts off after 59 seconds. One guy suggested I replace circuit board. Another guy says it could be several things. Any specific advice?Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t2345525-turns_off_after_59_secondsTurns off after 59 seconds.Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t2153167-when_press_start_hear_internal_fan_butMy Sharp r-1874 microwave, out of the blue, just quit working. When you press start the fan runs inside, but the table does not turn inside and no cooking takes place. Please help.Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1850877-gound_fault_outlets_located_holidaywhole passenger side electricle is offWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1593403-microwave_key_pad_stopped_workingI have a bult-in Sharp Carousel II Convection Microwave Model #R-1800A Serial #127308 650w manifactured fed 1985, they key pad stopped working and lcd screen disply 88888, I unplugged it and plugged it back also I shut off the power but screen still...Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1490174-sharp_carousel_convection_microwaveserial number 417281. it does not recoginize that i am pushing any buttons. it shows the simply the best press clear and press clock across the screen. when i do that the buttons dont even make any noise or recognize that i am pushing themWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1565139-fuse_blowing_sharp_microwave_r_1874Hi, I have had the tech out twice, once he replaced the fuse and once the stirrer motor. It's blown again and they say it has to go into the shop to be taken apart. what do you think? For today I have a fuse and would like to replace it! I've taken...Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1687216-sharp_1874_door_seems_jar_open_ovenSharp Convection/microwave R1874F in our motor home will sometimes stop working. It appears that either the top or bottom of the door will "jar itself open" during convection cooking or low bake. If the door is pushed lightly the oven can be started...Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1352981-remove_door_from_our_sharp_r_1874I need to remove the door from our Sharp R-1874 microwave convection oven after the glass in the door shattered. I have the door now if I could just find out how to install the new oneWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1510466-sharp_r_1874f_low_convection_tempI can't get the convection temp to go above about 300 degrees. ?I can get higher reading immediately next to the heat vents on the left side, but anywhere else in the oven stays much cooler. ?Food is not cooking properly. ?For example, a 6 lb ham,...Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1456491-microwave_oven_shuts_off_after_oneSharp microwave/convetion oven. Time cook microwave will tuen off after one minute and will restart immediately via the start button. The time will continue to count down and complete in one minute events. The controller was replaced and has the same...Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t819382-sharp_r_1874_59_sechow do i get the front off, its a built-inWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1339763-problem_sharp_r_1874tf_convection_ovenOVEN JUST QUIT WORKING. IS THERE A WAY TO SEE IF CONTROL BOARD IS BAD ON SHARP R-1874TF MICROWAVE CONVECTION OVEN BEFORE REPLACING IT?Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1191808-sharp_microwave_oven_model_r_1850on light on display, fuss is goodWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t978244-microwave_removalMy Sharp R 1850 A microw/covection oven in my 2000 HR Endeavor died. I need to remove it. How do I get at the bolts that hold it in place. Is there any place I can get a diagram to show me how it was installed? Thanks, GlennWed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t545527-sharp_carousel_model_no_r_315f_s_cThe start button does not work.Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t231347-shuts_off_after_59_secondsMy R-1874 microwave/convection oven shuts off after 59 seconds. Help!!Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t1315923-sharp_model_1451_blown_power_fusePower fuse blew and after replacing it I found it blows almost immediately. I turned the turntable off and it still blows almost immediately.Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t189446-panasonic_micro_combiOven fine but microwave not working?Wed, 23 Dec 2009 15:30:04 GMThttp://www.fixya.com/support/t211820-magic_chef_1_0_cu_ft_convectionMicrowave not heating.Wed, 23 Dec 2009 15:30:04 GMT