Since Sportcraft no longer replaces batteries in their heart rate monitors, I'll need to know how to...
(More)
Since Sportcraft no longer replaces batteries in their heart rate monitors, I'll need to know how to do it myself. The receiver/watch has screws on the back, so this will be no problem. However, the transmitter that straps to the chest has no outwardly visible means of case separation. There is a front nameplate that may grant access, or two pyramid-ish shaped inlays on the back, one at each end near where the pick-ups are, although there is no place to insert a tool to pry them out to access any fasteners. The case halves are so tightly mated that I doubt simply prying them apart will work without damaging the unit. I don't have a strong, miniature vacuum device, so I was thinking about super-gluing a handle of sorts to the inlays on the back to pull them out, assuming that they are merely press-fit in. But, then, cleaning up the glue with acetone thereafter is sure to dissolve the plastic, rendering the unit non-watertight, as would any drilling. Sportcraft did suggest possibly taking it to a jeweler, so what I need to do can be done with the ''right'' tool(s), but I haven't a clue what it/they might be. Aside from chucking this one, and buying a new unit, has anyone any ideas? Thanks.
when i signed up i wrote what i needed to write down and then i pressed the button at the bottom and...
(More)
when i signed up i wrote what i needed to write down and then i pressed the button at the bottom and then it came up that i did'nt write my location thats the bit im stuck at can you please help me?
I have just bought a Tesco OneBody pedometer and cannot fathom out how to reset it after each use....
(More)
I have just bought a Tesco OneBody pedometer and cannot fathom out how to reset it after each use. The instructions are worse than useless - it took me ages to set the time and I'm not normally considered stupid! Thanks Gill