http://www.fixya.com/support/maytag/dishwashersSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comSat, 30 Aug 2008 06:10:10 GMT80http://www.fixya.com/support/t125594-jet_dry_not_draining_no_clog_as_far_asmy jet clean/quiet pack will not drain after cycle is done, is the dial junk?can it be replaced someone mentioned it was the dial/relaySat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t134763-rinse_aid_not_dispenseLast time I filled the rinse aid dispenser was 3 months ago. It's still full!Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t123642-handle_replacementHow do you replace the "latch" handle on the latch assembly?? I have both of the parts but there is no way of installing the handle on the latch assembly. Thank YouSat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t131155-flashing_ledsAll indiactor lights on the control panel are flashing and no response to the keypad.Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t129139-stops_in_middle_wash_cycleMy dishwasher runs part way thru the wash cycle and then stops washing. It does continue a blipping noise that isn't loud, but still isn't washing the dishes. It will stay there forever unless I manually turn it off. I can then start the wash...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t103178-arms_dish_washer_moveThe spry arm at the top and the bottom won't move. Water still comes out.Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t620564-magtag_mdb6650aww_dishwasher_will_notI've changed the inlet value and the water line is fine, disherwasher still dose not fill????Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t609120-buy_stainless_steel_door_2_yr_old_maytagWe've renovated our kitchen and my wife wants to replace our dishwasher because teh new look is stainless steel and not Bisque or Almond. Can I buy a stainless steel door for my 2 yr old Maytag Bisque Dishwasher MDB6601AWQ? The equivanent model...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t437567-maytag_jetii_dishwasherVery little water comes out of jets during wash and Rinse cycles. Water does drain from tub to drain though.Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t426869-food_deposits_left_dishesI have an increasing amount of food deposits on clean dishes. (Nearly 50%) If I run 2 cycles, it's only about 10%. I pre-wash the dishes before going in the washer, and still have a problem. The dishwasher worked fine a month ago. I have tried since...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t410300-door_handle_brokeMy door handle popped into the door and now it is locked. How do you get it out so I can open it?Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t397564-maytag_mdbh955awduring drying cycle steam comes from right side not only the left side where the vent holes areSat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t364539-dishwasher_control_panel_not_light_upMy dishwasher control panel does not light up( this means all the lights) but I can still press the start and a cycle will work (I have no idea wich one) I can press all the push buttons on top and nothing happens. what can be the problem ??Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t322272-dry_light_lit_up_start_maytag_jetdryThe "Dry" light on the control panel is permanently on The dishwasher will not start and is unresponsive to any button pushes. The 1st number on the time display is blank and the 2nd number shows "_"Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t303056-problem_admiral_dwd1500awbOur Admiral DWD1500AWB has stopped and won't start again. We opened the door mid-cycle. Have done this many times, and it always starts up again when the door is closed. There are two LEDs blinking on the front panel: "ON" and "CYCLE" (Normal). We...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t284626-mdb8750aws_dishwasher_dead_no_frontI checked and I have power past the door switch at the circuit board, Is there a way to tell if the problem is the circuit board or the front control membraneSat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t235226-maytag_mdb6600awwUnit is approx 3 years old it was finishing a load and stopped part way through sticking on heated dry. I don't know if it was there in the cycle or if the diagnostics on the board sent the message there. The light now will not shut off or move from...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t207109-maytage_dishwasherMachine is just over a year old. Started making loud sounds as if it was working to hard.Vibrating humming sounds. There is nothing in the way or jammed. Any suggestions before i call for repair.Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t184255-maytag_mjd_2005dishwasherdetergent dispenser does not open sometimes therefore won't clean properly,can we just put detergent on door and run dishwasher?Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t180972-fills_water_but_washMy dishwasher fills with water and heats up but thats it. I let it run an entire cycle and the dishes did not even get wet. What do I do?Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t190624-dishwasher_keeps_throwing_circuitI have a Maytag Jetclean estimated to be approx. 11-14 years old. Just recently it stopped working. I thought it had kicked the bucket, but was told that most dishwashers run on their own circuit so I went downstairs to find that it was the meer...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t169396-dishwasher_repair_or_replaceI have a 10-year old KitchenAid KUDA220T diswasher and both racks are rusted to the point of needing replacement, at a cost of $275 (for both). Also, the tub has a couple of spots where the porcelean has been chipped and the undelying metal...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t195545-maytag_dishwasher_model_mdbtt59awWhen I press the cycle I want, i.e. Heavy Wash, the green lights go on but when I press Start nothing happens at all. After about 20 seconds the lights go out and that's it. I had also been noticing that lately it seemed to be taking longer and...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t161125-noise_no_waterI have a maytag pdb2430. It's worked fine for a number of years until it started to make a loud noise when set to start. No water came into the machine either. With past machines I have changed the inlet valve when we had this problem and that has...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t169401-maytag_dishwasher_dirty_glassesWe have a DWU9962 Maytag dishwasher and we have found that quite frequently the glasses placed at the end of the rows in the upper tiers have a gritty or sandy residue left streaked on the insides. This typically involves careful inspection...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t169402-maytag_kenmore_dishwasherWe are currently deciding between a Maytag Quiet II Plus (#MDB6000) and a comparable Kenmore. My biggest priority is load capacity, second is noise level (I figure they can all wash dishes properly). The salesman at Sears suggested that the...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t206310-flashing_lightsMy dishwasher will not work. All the lights are flashing. Is there something that can be done to reset the dishwasher?Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t201219-dishwasher_optionsI have a Maytag jetclean dishwasher that has a salt light on it, what salt is used in it?Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t152003-not_drainingAfter cycle is complete, there is still unclear water at the bottom of the dishwasher. Upon waiting a period time it will usually drain the second try. Or third. The dishes need a full wash after it recovers because of the film on them. We have...Sat, 30 Aug 2008 06:10:10 GMThttp://www.fixya.com/support/t191801-maytag_mdb9150Can you please tell me how to remove the uppper spray arm. It is plugged with fish debris and I don't know how to remove it so I can clean out the holes.Sat, 30 Aug 2008 06:10:10 GMT