http://www.fixya.com/support/kawasakiSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comWed, 23 Dec 2009 12:23:12 GMT80http://www.fixya.com/motorcycles/t3662059-size_main_jet_pilot_jet_standardWHAT SIZE MAIN JET AND PILOT JET ARE STANDARD WITH THE BIKEWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3542221-2007_kawasaki_kfx50_starts_idles_fineMy 2007 Kawasaki KFX50 starts and idles fine, but after about 10 minutes of riding it acts like its either starving for fuel or floodind out. I have replaced the spark plug, air filter, cleaned the carb, drained and refilled the gas tank with new...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/support/t3355344-plastic_blower_baffle_assembly_seemsTHE PLASTIC BLOWER BAFFLE ASSEMBLY SEEMS TO HAVE DISENTIGRATED AND MELDED ON CASING OF BLOWER. I NEED PART # AND REASON WHY THIS HAPPENEDWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/support/t3329868-06_brute_force_750_back_firing_thruMy "06" Brute Force 750 is back firing thru the carburators and will only idle with the choke on. It's been setting up for several months. What's could be the cause and cure ?Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3257151-95_kawasaki_vulcan_800_here_latelyI have a 95 Kawasaki Vulcan 800. Here lately I just can't get it to act right. I keep having a problem with lots of raw gas pouring out of the exhaust pipes. I have had the carb professionally cleaned twice in one month. All new vaccum hoses, plugs,...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3234357-99_300_kawasaki_bayou_4_4_when_climbi have a 99 300 kawasaki bayou 4+4 when i climb a hill or lug it down it make a loud clunking sound in the motor area but does fine on flat ground i have checked all the u joints and are okWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3142701-engine_dies_when_choke_taken_off_or_whenHelp! My problem in a nutshell. The only way my bike will start (cold or hot) is if I apply full choke. As soon as I take the choke off, or when I apply or blip on the throttle, the bike dies. I had the valves adjusted, and the carbs cleaned twice,...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3134894-kawasaki_zzr400_after_washmy kawasaki zzr400 after wash Occasionally it'll run for a couple of seconds and shut off. I I turn on throttle it shuts off even faster.Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3120802-need_wiring_diagram_175_cc_kawasaki_keI need a wiring diagram for my 175 cc Kawasaki KE 1976 all the indicator wiring pluss lights have been stripped off the bike pluss?? whats the other spark plug in the head for ?Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3097166-kawasaki_zzr250_start_when_turnmy kawasaki zzr250 won't start. when turn on the key, no light on meter. new batteryWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3064801-kfx450ri HAVE A kfx450R that won't start by the motor but will actually start when it is bumped. Now the FI light is flashing when it is cranked but it won't start. The pump purges and when I removed the injector it did spray fuel but only once and while it...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3057015-air_box_crank_case_fuel_flooding_problemAir box and crank case fuel flooding problem happened before, thinking it was stuck or worn float needles; I installed 2 Carb float needles left side facing rear of carbs , all larger main jets, all slide needles. Plugged vacuum hoses going to...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3037335-2003_vulcan_nomad_1500_will_not_start2003 VULCAN NOMAD 1500 WILL NOT START AND STATER DOES NOT ENGAGE AND LIGHTS GOES DEAD WHEN TURING KEY TO START POSITIONWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t3023487-causes_kawasaki_185_bayou_miss_highWhat causes a Kawasaki 185 Bayou to miss at high rpm?Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2997881-2007_kx250f_dirt_bike_running_richON A 2007 KX250F DIRT BIKE IT IS RUNNING RICH EVERY TIME I REV IT A FLAME SHOOTS OUT OF THE EXHAUST IF I AM LOOKING AT FRONT OF BIKE CARB IS ON RIGHT SIDE WHICH WAY DO I TURN THE SCREW ON THE BOTTOM OF CARB TO LEAN IT UP A LITTLEWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2988549-terrible_knocking_slapping_noise_tellKids (I assume) pushed my zxr 750 over while I was away. came back to find it on it's side. Initially it smoked loads, would not accelerate and felt like was only running on two cylinders. Drained the oil and found it to be silvery grey. Put new...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2985977-zxr_400_h_will_go_into_neutral_1stmy zxr 400 h will go into neutral, 1st gear, neutral, no problem but wont select any of the other gearsWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2970069-bayou_300_cranks_stops_after_minuteHave a '93 Kawasaki Bayou 300. It will crank but dies after a minute then if I let it sit I hear inside the engine a sound of pressure relief. It also backfires going down hill even in high gear. I had the carb cleaned and it has new gas.Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2967357-just_purchased_1997_vulcan_1500i just purchased a 1997 vulcan 1500 classic.Every time i shift into 2nd i miss it and it goes into nuetral is there a problem or is it just me.Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2948860-kawasaki_gpx750_any_other_handlebars_fitkawasaki gpx750 do any other handlebars fit this bike as it is too sore on my wrists,could bars from another bike be fitted? the ones on the bike are not the traditional type with the little cradles for holding the bars they seem to be part of the...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2919150-1996_zx6rI know this sounds ridiculouse but i can`t figure out how to take out my light bulb in the front and also i am looking for the rear fairings for my bike thanksWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2907311-kawasaki_kx_65_bit_tall_sonkawasaki kx 65 is A bit to tall for my son. how do I lower it and how much can I lower it.Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2885781-zxr_750_l2_model_problemhi i have a zxr 750 l2 model and i have a problem with my bike. the problem is that when the bike is going straight or downhill or behind traffic the bike seems to sputter a bit like small pops but when you are going up a hill it dosent even if you...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2883754-kawasaki_gt_550_replace_fork_seals_needJust picked up a GT 550 from my a relative. 1. Fork seals need replacing. I just need How to advise 2. Bike starts but won't idle and its overflows fuae. I'm thinking sticky floatsWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2836452-kawasaki_kmx_125_b11_ve_justHello!, My Kawasaki KMX 125 (B11). I've just had a 0.5mm Re-bore, Nicosil plate, Over sized piston-rings Etc... (Due to seizure because some Muppet didn't Aline the piston rings correctly!) The bike has been run-in and it still doesn't feel quite...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2834693-94_vulcan_1500a_back_fires_when94 vulcan 1500A back fires when you decelerateWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2824094-am_amateur_mechanic_working_kawasakii am a amateur mechanic working on a kawasaki zx6r 07 race bike any advice for me that might help me along in the futureWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2822507-im_replacing_piston_rings_tookim replacing my piston and rings and i took the cylinder and cylinder head out and i dont know how to time the engine , the sproket has a mrk on it and i dont know if i shuldput the piston all the way down and pput the sptoket mark pinting at 12 o...Wed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2822390-kawasaki_z1000_wont_start_f1_lightkawasaki z1000 wont start you turn the ignition on and the f1 light flashes it turns over fine. i only went out on it only 2 days ago and no problem and never had a problem with it i have had the z1000 now for 2 yearsWed, 23 Dec 2009 12:23:12 GMThttp://www.fixya.com/motorcycles/t2793720-bought_kx250f_05mod_bend_rodbought a kx250f 05mod with a bend rod and destroyed cylinder head. bought everything new, and now it would not start,i have spark, and it is fuel on the spark plug. what can be wrong?Wed, 23 Dec 2009 12:23:12 GMT