http://www.fixya.com/support/haier/dishwashersSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comSat, 12 Dec 2009 03:04:33 GMT80http://www.fixya.com/support/t2540019-haier_dishwasher_hdp18pa_power_resetI have a Haier portable dishwasher that keeps blowing the outlet fuse. I have tried plugging it in multiple locations. It blows the fuse when i press the power button.Sat, 12 Dec 2009 03:04:33 GMThttp://www.fixya.com/support/t2357488-haier_dishwasher_wont_run_shows_code_opdishwasher Haier model ESD401 Haier dishwasher wont run and shows a code OPSat, 12 Dec 2009 03:04:33 GMThttp://www.fixya.com/support/t1961004-need_service_manual_haier_hdt18palooking for service manual to diagnose and repair this model dishwasherSat, 12 Dec 2009 03:04:33 GMThttp://www.fixya.com/support/t1485833-all_4_lights_haier_dishwasher_modelthey will bink and beep for 10 times and then continue to blink but stop beeping and for a few seconds and then do the same thing over again.Sat, 12 Dec 2009 03:04:33 GMThttp://www.fixya.com/support/t1635301-brand_new_dishwasher_will_not_drain_endJust installed yesterday - a new Haier ESD300. I ran two cycles and both times it left an inch or two of water in the tub once the cycle was complete. If I hit the cancel/drain button - it pumps out the water and everything is fine. During the wash...Sat, 12 Dec 2009 03:04:33 GMThttp://www.fixya.com/support/t2732448-fitting_needed_connect_water_linewhat fitting is needed to connect the water line to the back of the dishwasher. It has a plastic 3/4 or 1" pipe thread (I think) out the back side. It came with a standard brass elbow, but it seems to be missing a fitting to adapt to the plastic...Sat, 12 Dec 2009 03:04:33 GMT