http://www.fixya.com/support/browse/pressure_washersSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comTue, 22 Dec 2009 07:13:09 GMT80http://www.fixya.com/support/t3536476-pressure_washer_not_sending_out_enoughpressure washer is not sending out enough water to pressure washTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3499292-motor_will_not_startmotor will not startTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3443999-karcher_k4_97m_electric_waterblasterI have a Karcher K4.97M electric waterblaster that has started behaving strangely. When it's powered on, but the trigger is not pulled, it continually cycles on and off (about a 2 second cycle - almost as if its building pressure but not holding it)....Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3432323-pressure_washer_will_run_choke_die_whenpressure washer will run on choke and die when trigger pressedTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3349156-john_deere_3300_psi_pressure_washerJohn Deere 3300 PSi pressure washer shutting off while in use.Everything appears fine Oil level,Gal level,Air cleaner ok etc.. May run 2 minutes or 12 minutes then spudders a bit then Bang "Off" as if i turned it off.May or may not restart after a...Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3332615-8hp_honda_engine_log_splitter_costantly8hp honda engine on log splitter. costantly stalls as governor opens throttle to maintain rpm. engine starts to stumble then stalls. When revved with throttle acts similar. somewhat better when hot, somewhat better at half choke. have pulled carb and...Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3280220-torque_specs_5hp_briggs_ampWhat are the torque specs for a 5hp Briggs & Straton Engine (it is on a log splitter)?Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3157574-winterize_pressure_washerWhat do I have to do to winterize my pressure washer? It will be in an unheated shed all winter.Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3136133-pw1686_power_washer_but_runs_fewI have a PW1686 power washer but it runs for a few minutes then cuts off. After a few minutes it starts again then goes through the cycle of on and off. Kindly tell me what are the possible causes.Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3097532-powerboss_3000_psi_honda_ran_about_hourPowerboss 3000 psi Honda ran for about hour then big spark out of muffler and it stalled. refused to restart. What do i do?Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3088724-no_pressureno pressure. just hums lightly every few mins? agghhh. just bought it second hand. Thanks.Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3064760-no_pressure_but_some_times_pressure_butno pressure,but some times have hi pressure, but just for a few seconds. The person before me had the machine without been used for long time now has this problem. only had pressure for 2 times than nothing again help me please. Thank's AstroTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t3022395-r_nmy_pressure_will_start_but_will_notHi, My pressure will start but will not stay running, it revs up and then craps out in 10 seconds. Any ideas? ThanksTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2976053-karcher_3500_hd_2_1_head_machineI have a Karcher 3500 hd with a 2.1 head. Machine has always worked well but lately it has been pulsating. High pressure then low... repeat. I have checked valves and they seem fine. Any advise would be great thx.Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2973482-motor_keeps_surgingHi, I have a Karcher KB4040, When it is fully connected up to water & electricity the motor keeps on surging trying to build up pressure, It still runs but it is on half power. I have checked the filter, water supply, kinks in the line &...Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2944971-hose_connectionsI have a McCulloch FHH18A pressure washer. Does anyone have a diagram showing where the ends of the hoses for the two tanks should be attached at the tank selector? I took it apart and neglected to make a diagram for reference.Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2886554-type_oil_pressure_washer_pumpWhat type of oil should I be putting in my pump of my Campbell Hausfield pressure washer?Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2818143-power_washer_will_not_start_pull_cordPower Washer will not start - pull cord seems to be stuckTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2746582-2200_gc_karcher_pressure_washer_oil_gotMy 2200 Gc Karcher pressure washer oil got mixed with waer and I need to replace it. What oil should I use?Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2715118-when_release_trigger_idles_fine_butthe trigger it does not go back into the high pressure spray mode. I get a very weak stream.Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2665620-partsWhere can I get replacement parts for McCulloch 1600 psi jet washer? The adapter at the bottom going from the hose to the body is broke.Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2663517-engine_not_start_ran_about_two_weeksEngine does not start. I ran it about two weeks ago and it worked fine. I took the spark plug out and it was dry. I made sure there was gas in it. I tried some starting fluid by spraying into air intake and it start running for a short time until the...Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2644013-fine_parts_blue_max_perrurewere can i fine parts for a blue max perrure washer .call me back at 229 759 6659. thanksTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2624360-ge_model_gxsf27e01_water_softenerWe have a GE Model GXSF27E01 water softener. It ran out of salt, so we unplugged it until we could get some salt. When we filled the salt container and plugged it back in, it failed to power up. The transformer is putting out the proper power, but...Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2618584-tried_use_karcher_washer_model_411aI have tried to use my Karcher washer model 411A using the suction tube which is immersed into Patio cleaner bottle but it does not work what am I doing wrongTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2543015-lost_high_pressureran pump low on oilTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2529545-no_pressure_build_upno pressure build upTue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2527274-porter_cable_pcv2250_pressure_washerI have water shooting out of the siphon valve barb at the water out. I took the valve out and put back in with no success. Any suggestions?Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2526906-karcher_2_600_psi_2_3_gpm_gas_pressureI have a Karcher 2,600 PSI 2.3 GPM Gas Pressure Washer G 2600 VHR that I have used once last summer. I have stored the PW in my basement with no fuel in the gas tank. The PW was never exposed to freezing temps. I cannot get the PW to start. I put new...Tue, 22 Dec 2009 07:13:09 GMThttp://www.fixya.com/support/t2504967-dewalt_pressure_washer_valve_brokenI removed the pump and took a look inside my non-functional pump's cylinder to check for broken parts. Sure enough, part 355 is all busted up. However, I don't know how to get to it. Here's the schematic: ...Tue, 22 Dec 2009 07:13:09 GMT