Question about Peavey Audio Players & Recorders
...POWER AMP 1 and 2 input jacks on the front. This will prevent the power amps in the XR8600 from running with no load which COULD damage them. Make the grounding plugs from 1/4 inch mono plugs by ...
Question about Audio Players & Recorders
power amp, the problem is i have no access to a manual, and i have no idear how to set them up for the best effect. I have tried looking for diagrams on the net but not found any. A better solution is
...power amp or if it has an output IC - that! If you can in anyway disconnect the power supply section from the amp circuit, you can isolate which part is faulty. For if it blows when disconnected from ...
POWER amp to do anything useful, such as drive a spleaker, or a relay, or a transducer. For your question, most all audio amps consist of stages. There is an input/pre-amp stage (this is usually where
...Amp to Power Amp I have an older Kenwood KA-7100 in great condition. I'd like to use its preamp section to run a larger power amp. There are no "pre-amp outs" on the Kenwood. Is there a way to link ...
Question about Yamaha Audio Players & Recorders
power amp, the sound level from the Turntable is too low.Sound like the Power Amp is doing nothing. If you can hear music with the volume up, but like it was turned down low (from the power amp), then
Question about Bogen Communication Audio Players & Recorders
...amp out , power out, vox, alc... & what is aux dfrs??? Tape out and tape in are to connect the record and playback leads of a tape deck. Pre-amp out is to connect a Power Amp to the unit. The ...
...power amp Hi i have a problem wit my lexicon power amp, a buzzing/hum coming from all the channels. Its only very faint when its just the power amp on and nothing is connected to it but the speakers. ...
...POWER AMP. The pre-amp does some amplification and then it passes the signal along to the power amp, which will do the heavy lifting - driving the speakers. The connection is usually through a ...
Question about Technics Audio Players & Recorders
...power amp i suggest u check all the paths from pre-amp to power amp. bad resistors cud be it, faulty capacitor cud be draining power to ground. insufficient power supply to final amp cud also be it. ...
8 questions posted
Usually answered in minutes!
9 Questions
4 Questions
6 Questions
2 Questions
1 Questions