DEI Python 1400XP Remote Start/Keyless Entry System "valet switch led" Questions

valet switch location disable alarm The valet switch is usually located around the drivers side. Each installation is different, as are most alarms. The valet switch could be part of the flashing

...that is the process for "remote valet". If that does not work, turn igniton on then off, within ten (10) seconds, press and release the valet switch. The LED will go out if the system was in

...valet switch on my car so I can set up a replacement transmitter. The valet switch on that model is part of the "control center". The antenna, LED and valet switch is all one piece and is most likely ...

...valet switch on a used 1995 Honda Accord that I purchased. It came with this alarm system installed, however the one remote that came with it is almost broken, so I purchased a matching one. But now ...

...valet switch on my remote controller The K9-Eclipse has a push button valet switch. The switch is about 1/2" in diameter and about 3/8" in height. I can be installed anywhere but it is usually under ...

...it should be located near the valet switch. It's a toggle switch that may still have a red boot over it. Flip the switch in the opposite setting. The remote starter should work

...OR Turn the key on then off. Within ten seconds press and release the valet switch. The LED should be off now. Close the door and arm the system. The alarm should chirp to confirm that it is

...switch off and see manual and instructions I am assuming that you want to disable the system temporarily by putting it in valet mode. You will need to locate the valet button; they are usually ...

valet switch, your alarm is most likely in valet mode (youll know cause the led stays on) if that doesnt work, turn the key on and off then toggle thye valet switch 3x and that'll turn off silent mode

valet switch within 10 seconds The status Led will light solidly if you are entering valet mode, and it will go out if you are exiting valet mode. To enter or exit Valet Mode using the transmitter: 1.