2007 Yamaha XT 660 R "set float fuel level" Questions

...set your float level. The picture below will allow you to become familiar with the parts that are responsible for maintaining the correct float level in your carb. There are four basic parts, the ...

...set the float levels I built a jig from wood that simulates the position of the carbs when mounted on the bike. This jig clamps into my bench vise. I created a fuel supply using a small funnel and a ...

...set float level,right floods,left sets to low Carby floats don't set.Removed several times & adjusted the floats. It doesn't change the fuel level in the carby bowl. Checking this by fuel tube level ...

...float level was set correctly because it would continue to flow past the needle ans seat when the float had risen to the proper shut off point. In this case it might leak out of the main discharge ...

...float level and air setting the air screw gets turn in fully and the turned out 2 turns this will set it right for most bikes you might have to play with it either half a turn either way When setting ...

float height set before i reinstall on bike . what is the float height spec.???? Float tabs come set flat to surrounding plate, bend up to decrease level and down to raise level. Raised level too much

...the height to 0.413-0.453" from the carburetor flange surface to the top of the float. I usually try to set the float at the lowest fuel level setting with would be the 0.453" setting. Good Luck ...

...set floats? how to adjust carb floats &needle&seat - Now days some carburetors are produced which are fixed and no adjustment is provided.The float is made up of whole plastic like material. Some ...

set the float level several times. I assume you know the float level sets with the carb on angle of 15 to 20°. One thing you try is setting the float level so that it's about one millimeter

...float bowl level is set in between running it dry at full loaded throttle and fuel overflowing from overflow hose. The floats have a small brass tab that bears on the needle, when it rises, it pushes ...