Question about Yamaha XT 660 R Motorcycles
...remove wheel. with same aluminun rod, tap the bearings out, from the inside out. its agood idea to use new bearing seals too. put it all back together, same sequence as removed. dont forget to grease ...
...bearing off, i've never been able to remove those bearings without ruiing them. that bearing is a very tight fit. Hope this helps you out. thumbs up to the do-it-yourselfers Best regards Big ...
Question about Yamaha XT 660 R Motorcycles
...remove and re-insert the pivot bearings. Consult with your local dealer and find out how much they charge to do it, then decide if you want to tackle it on your own. Keep in mind that if they charge ...
Question about Yamaha XT 660 R Motorcycles
bearings? With the "clunking" noise (if in reality, more of a "knock"), I'd tend to believe a connecting rod big end bearing. BUT, it'd be easier to check the cam bearing first, plus you'd have to get
...bearings when worn will sound noisy and feel rough, the big end may lock up when worn,bring the con rod to the top, in the middle of the big end where the pin holds it to the crankshaft, you will see ...
...remove the excess free play, but leave a slight amount of play or you can damage the bearings. If after doing the above the steering head is hard to move you either have damaged/worn steering head ...
125 DRAGSTAR. CAN YOU ADVISE ON THE POSSIBLE CAUSE? That could be big end or main bearings. You won't know for sure until you take the crank out or remove the barrel and check for play in the bearings
Question about Motorcycles
...gear input shaft bearings
looks like it is a pull down and rebuild
remove the plug first to see if there is coolant on top of the piston and causing a hydraulic lock--if water cooled ...
...big ends and main bearings on the engine as well. I have replaced the bearings with the correct colours and plastic gauged the bearing as well. I didnt took the crank out. I have lifted the crank a ...
...bearings? hi, this all depends if you are talking about, a machined crankshaft, or a press fit crankshaft? is this a 2 stroke? or a 4 stroke engine single cylinder multi cylinder. normaly you will ...
85 questions posted
Usually answered in minutes!
12 Questions
9 Questions
8 Questions
4 Questions