2003 Yamaha YZF-R6 "replace inner throttle cable" Questions

...inner wire, a pinched cable, a cable gummed up with dirt, a gummed up twist grip assembly, an abused outside end of the twist grip and the twist grip assembly forced too deeply into the handlebar. ...

...inner throttle cable on a 1973 flh and get the length right? If you're talking about the old style throttle cable that is internal of the handlebar, it's pretty straight forward. Remove the throttle ...

...inner cable you will probabely see rust pouring out below contniue doing so until theres frsh oil dripping and by then your bike's throttle cable should be opareting freely. Hope this works! ...

...inner cable out through the mounting plate hole. If you will reuse the cable wash all components in non-flammable cleaning solvent, carefully blow all parts dry with low pressure compressed air, ...

...throttle slide is usually very small and will go through the adjuster and in that case the adjuster won't be supplied with a replacement cable - the adjuster usually screws into the top of the carb. ...

my throttle round it clicks at the half way point also it wont always return on its own Sounds as if the inner cable is starting to fray and catching in the twist grip. If so cable will need replacing

...inner face of the housing by a single screw. Take the switch loose and desolder the two wires leading to it. Replace the old switch with a new one and solder the original wires to the new switch. ...

inner cable exits. This will lube the cables. The rough running is probably a result of dirt somewhere, either the carburettors, or the ignition system or it might even be muck in the fuel line coming

...inner and outer carbs use some different size jets and it's important to not mix them up. If you have dial or verneer calipers, measure and record float heights. Perform measurements with floats just ...