2003 Yamaha YZ 125 "waterpump" Questions

...crank or the pistion it is the clutch side casing take it off and put it back up it stops the crank waterpump and clutch for going ...

...water pump, what is this hole? Should it be plugged off? This hole is to check the tightness of the waterpump axle joints. No water should drip from there. replace the water pump, or if you are fine ...

...cover,place small allen key in slot provided & remove bolt on actuator,remove radiator to waterpump hoses,remove clutch cover,slide shaft out from left to right,(If clutch hub is in the way ...

If this fails after a few attempts, your plates could be rusted together - possibly from a leaking waterpump seal or a ride through deep water. A simple tear-down of the clutch will tell the tale and

...drain hose hanging down from the motor, follow the hose and if it goes into the engine near the waterpump this is what is commonly referred toas a "tattle tale" hose and is indicating by the leak ...

...oil dripping out of my 2001 rm250.. What do i do? White oil is normally an indication of a leaking waterpump seal. You would need to repalce the waterpump seal which can be a challinging task unless ...

...1997 ktm trail bike water in gearbox and oil in radiator marzy306, Your problem is coming from the waterpump seal. When the seal goes bad it lets oil from the crankcase into the waterpump and vise ...

How do I go about Timing the Cam I have a 2005 Husqvarna TE 510, and I recently removed the waterpump to check out a leak, not knowing that pulling out the waterpump, messes with your cam timing. The ...

leaking water underneath waterpump,looks like it's coming out of the overflow. How can i fix this? if its the overflow it will be a tube that goes to the overflow tank, if its coming out the small ...

waterpump impellar removal How do you remove the waterpump impeller First you want to remove the water pump cover, under that you will see the impeller and it should have a 6mm bolt, (10mm head), that