2001 Yamaha YZF-R1 "opposite opposition" Questions

...red and black wire from battery and any brackets or straps holding your battery in. Replacement is opposite of removal. INSURE battery wires are RED to positive + side of batt and black to negative

what is the head bolt torque spec for a kawasaki 250 bayou 28 nm buddy make sure you tighten them down evenly like opposite to opposite

...the pivot bolt. (you will find that after you remove the pivot bolt) * Move the tip of the clutch opposite of normal operation until it is pointing strait forward, it puts the lever in position to ...

...hardly matter, it could be tapped back straight with a small hammer and a block of metal on the opposite side of the bend. If the spoke is loose it can be tightened, If the wheel still runs true, ...

...now Ive cleaned it up. I benched tested spins fast and free. And I took the plate of the engine opposite starter motor. Chogs all good . Seems like starter motor spinning wrong way. If I remove ...

...leather coat, trim the hole neatly, and carefully grind out the slow slope with sandpaper on the opposite side of the edge of the hole grain, so that it is not obvious when sticking the leather. ...

...about this,but one has said the heavier cover definately goes on the left side and another shop the opposite.l hope someone knows about this, as if l get it wrong my bike will start handling like a ...

...to what you would do when you ride it to remove it from the bendix throttle system, replace in opposite manner using a small amount of grease inside the metal sleve, PE, ...

to one side. Get a chisel or an old screw driver and tap the inner race of the bearing out from the opposite side. Save the spacer. Flip the wheel over and tap out the other side. Grind the outer edge

the cap opposite the gas tank with the gauge has a wire that is exposed from twisting the cap You are correct, the gas gauge cap should not have been twisted. Only a bike shop or dealer can replace it