1997 Yamaha YZF 600 R thunder cat "clutch" Questions

...when under heavy load or... Yamaha yzf 600 Thundercat when under heavy load or rapid acceleration clutch dissengages & engages again checked cable! clutch works most of the time does not slip! just ...

The bike will go in gear but the clutch won't The bike will go in gear but the clutch won't release Remove clutch slave cylinder & push piston right in then refitRide safeBike-Doc

...clanking noise like metal on metal near left crankcase , maybe broke a piston? Or bad starter clutch. Sounds like metal in a dryer. 2003 yzf600r I would check the clutch friction plates,, how ...

after replacing clutch plates will not go into 1st or fith gear, is this a transmission problem If the clutch is working in all other gears it would be working in 1st and 5th. It sounds like a bent ...

i want to change the sprockets on 99 yzf 600r yamaha but want to know if it will do any thing to my clutch when I remove the cover over the front sprocket were the clutch cable goes into? Removing the

Clutch slipping (only is 2nd gear), on yzf600r On my yam yzf600r thundercat 98 the clutch slipping (only is 2nd gear), is there a way of adjusting it other than the adjustments to the cable. Or is the

2006 yzf600r when shifting to 2nd get a loud,fast,hard knocking. I can hit the clutch and rev up fast and go to 3rd,or if not the bike will roll about 15 ft and stop then I got to turn the bike off to

Why is my 97 Yamaha losing torque I had replaced my clutch push rode because my chain slipped and snapped it. Along with the clutch friction plates and Clutch wire. The bike will lose torque after ...